5 Configuring the UAP. Huawei Technologies QISUAP2105

6 Routine Operation and Maintenance of the UAP2105

UAP2105

User Guide

6.2 Diagnosing Faults

This describes how to diagnose the faults in the AP, faults at the radio network layer, and faults at the transport network layer on the WebUI and how to view diagnosis results.

Procedure

Step 1 Log in to the WebUI. For details, see Logging in to the WebUI . Then, choose

TroubleDiagnose . The Execute Trouble Diagnose page is displayed, as shown in

Figure

6-2 .

Figure 6-2 Execute Trouble Diagnose

6-4

Step 2 Set Diagnose Mode and determine the type of a fault.

l l l

Equipment Trouble Diagnose : indicates the faults in the AP.

Wireless Trouble Diagnose : indicates the faults at the radio network layer.

transfers Trouble Diagnose : indicates the faults at the transport network layer.

Step 3 Set OutPut Mode and determine the output mode of the fault diagnosis result.

l l

Just Show Abnormity Result : indicates that only fault diagnosis results are displayed.

Show All Result : indicates that all diagnosis results are displayed.

Huawei Proprietary and Confidential

Copyright © Huawei Technologies Co., Ltd.

Issue 03 (2009-08-20)