Wireless N150/N301 Easy Setup Router
2 Wireless Settings
2.1 Wireless Basic Settings
If you want to create a WLAN for sharing Internet connection, simply click
Wireless-> Wireless Basic Settings . Change the SSID, you can name it whatever you like. For example, select 2437MHz (channel 6) and leave other options unchanged and then click OK .
1. SSID:
This is the public name of your wireless network. The default is
Tenda_XXXXXX. XXXXXX is the last six characters in the device's MAC address. It is recommended that you change it for better security and identification.
2. Channel
: Select a channel that is the least used by neighboring networks from the drop-down list or Auto. Channels 1, 6 and 11 are recommended.
3. OK:
Click to save your settings.
2.2
Wireless Security
Wireless Security Setup
This section allows you to secure your wireless network and block unauthorized
Wireless N150/N301 Easy Setup Router accesses and malicious packet sniffing. To encrypt your wireless network, do as follows:
1. Select the wireless network (SSID) you wish to encrypt.
2. Disable WPS. (WPS is enabled on the router by default. If you want to use other security modes, you must first disable the WPS.)
3. Select a proper security mode and cipher type (also known as WPA Algorithm or WPA Encryption Type). WPA-PSK and AES are recommended by system default (5 security modes are available for your selection. Among them,
WPA-PSK outstands with greater compatibility and security. For more information of other security modes, see appendix 2). Specify a security key that includes at least 8 characters.
4. Click OK to complete your settings.
Note
:
You can also select other security modes as you need.
WPS
Wi-Fi Protected Setup makes it easy for home users who know little of wireless security to establish a home network, as well as to add new devices to an existing network without entering long passphrases or configuring complicated settings. Simply enter a PIN code or press the software PBC button or hardware
WPS button (if any) and a secure wireless connection is established.
Operation Instructions:
PBC: To use WPS-PBC, try the way below:
Press the hardware WPS button on the router for about 1 second and then enable
Wireless N150/N301 Easy Setup Router
WPS/PBC on the client device within 2 minutes;
PIN: On the wireless security page, enable WPS , select PIN and enter the
8-digit PIN code from network adapter; then, within 2 minutes, enable
WPS/PIN on the client device;
Note
:
1. With WPS successfully enabled, the WPS LED on the router keeps blinking for about 2 minutes, and during this time, you can enable WPS on a wireless