advertisement
INSTALLATION INSTRUCTIONS
» Check the filter screen for scale blockage or dirt accumulation.
See section 12, “Troubleshooting”, pg. 19.
6.6 Maintenance and care
!
MAINTENANCE WORK, SUCH AS CHECKING ELECTRICAL
SAFETY, MAY ONLY BE CARRIED OUT BY A QUALIFIED
INSTALLER.
WARNING: ALWAYS SHUT OFF POWER AND WATER TO
THE UNIT PRIOR TO REMOVING THE FILTER SCREEN.
FAILURE TO DO SO MAY CAUSE SERIOUS BODILY INJURY OR
DEATH.
Regularly clean and descale the filter screen located in the cold water inlet connection and if necessary replace. Always shut off power and water to the unit prior to removing the filter screen.
A damp cloth is sufficient for cleaning of the unit's housing. Do not use any abrasive or corrosive cleaning agents.
7. Installation instructions
KEEP THESE INSTRUCTIONS CAREFULLY AND PASS THEM
ON TO YOUR SUCCESSOR IN THE EVENT OF A CHANGE
IN OWNERSHIP, IN THE EVENT OF MAINTENANCE AND POSSIBLE
REPAIR WORK THEY SHOULD BE PASSED TO THE QUALIFIED
INSTALLER FOR HIS OR HER REFERENCE.
7.1 Mounting the unit
!
UNIT MUST BE INSTALLED WITH THE PLUMBING
CONNECTIONS POINTING DOWNWARD OR UPWARD ONLY.
WARNING: DO NOT INSTALL UNIT WHERE IT WOULD
ROUTINELY BE SPLASHED WITH WATER. ELECTRIC SHOCK
OR DEATH MAY RESULT.
» 1. Install Mini as close as possible to the hot water draw-off point, for example, directly underneath the sink or next to the shower stall.
» 2. Install Mini in a frost free area. If frost may occur, remove unit before freezing temperatures set in.
» 3. Leave a minimum of 5" of clearance on all sides for servicing.
WWW.STIEBEL-ELTRON-USA.COM MINI ™ SERIES TANKLESS ELECTRIC WATER HEATERS | 13
advertisement
Related manuals
advertisement
Table of contents
- 2 General Information
- 3 Symbol key
- 4 Safety precautions
- 5 Register your product
- 7 Technical drawings
- 10 Overview
- 10 General Description
- 11 Hot water output
- 12 Incorrect use
- 12 First steps to be taken in the event of malfunction
- 13 Maintenance and care
- 13 Installation instructions
- 13 Mounting the unit
- 14 Plumbing connections
- 15 Electrical connection
- 16 Initial start-up
- 16 Water heater hand over
- 17 Normal maintenance
- 18 Technical data
- 20 Troubleshooting
- 21 Spare parts
- 22 Warranty
- 23 Información general
- 24 Explicación de símbolos
- 25 Precauciones de seguridad
- 26 Registre su producto
- 27 ambiente del agua
- 28 Diagramas técnicos
- 31 Resumen general
- 31 Descripción general
- 32 conectar la unidad a la red eléctrica
- 33 Salida de agua caliente
- 33 Uso incorrecto
- 33 Primeros pasos a dar en caso de mal funcionamiento
- 34 Mantenimiento y cuidado
- 34 Instrucciones de instalación
- 34 Montaje de la unidad
- 35 Conexiones sanitarias
- 36 Conexión eléctrica
- 37 Puesta en marcha inicial
- 37 Traspaso del calentador de agua
- 38 Mantenimiento de rutina
- 39 Datos técnicos
- 41 Resolución de problemas
- 42 Repuestos
- 43 Garantía