Memory Recall. REED R6200, R6200-KIT

Memory Recall

1.

Press and hold the MODE button to recall the recorded Temperature/

RH measurement values and sequential number.

2.

Press the HOLD button to scroll up the stored readings.

3.

To scroll down the stored readings, press the BKLT button.

4.

To exit memory recall function, press and hold the MODE button at which point you will be redirected into the WBGT alarm threshold setting.

5.

Press and hold the MODE button again to exit the memory recall function and resume normal operation.

Clear Stored Readings

When required, you can clear the stored readings by pressing and holding the SET button. The LCD display will indicate "---" confirming that the stored values have been cleared.

WBGT WBGT

WBGT Audible Alarm Threshold Setting

(The default WBGT temperature alarm value is set at 31°)

1.

Press and hold the MODE button for 2 seconds and the meter will enter memory recall function.

2.

Press and hold MODE button again to enter

WBGT alarm function.

3.

Press the HOLD button to increase the value.

4.

Press the BKLT button to decrease the value.

5.

Press the UNIT button to confirm your selection and jump to the next digit.

6.

Repeat steps 3 to 5 for each digit.

7.

Once the alarm is selected, press and hold the

MODE button to save the value and resume normal operation.

WBGT

% continued...

REED Instruments 9

1-877-849-2127 | [email protected] | www.reedinstruments.com

GT

%

MAX

MIN

AVG hpa

%

REC

GT

3

4

5

% hpa hpa