7. Where to Go Next. Cisco Firepower 4120 Security Appliance

Cisco Firepower Threat Defense for Firepower 4100 Quick Start Guide cisco-ssp-A# connect module 1 console firepower>

3.

The first time you connect to the module, you enter the Firepower Chassis Manager module CLI (at the firepower prompt). You must then connect to the Firepower Threat Defense CLI: connect ftd

Example: firepower> connect ftd

>

Subsequent connections place you directly in the Firepower Threat Defense CLI.

4.

To exit the Firepower Threat Defense connection, type exit .

Example:

> exit firepower>

5.

To access the system diagnostics, type system support diagnostic-cli .

Example: firepower> system support diagnostic-cli

6.

To exit the console connection, type ~ . You exit to the Telnet application. Enter quit to exit to the supervisor

CLI.

Example: firepower> ~ telnet> quit cisco-ssp-A#

7. Where to Go Next

 You can find links to all Firepower 4100 documentation at Firepower 4100 documentation .

Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of

Cisco trademarks, go to this URL: www.cisco.com/go/trademarks . Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1110R)

Any Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Any examples, command display output, and figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses in illustrative content is unintentional and coincidental.

© 2016 Cisco Systems, Inc. All rights reserved.

10