Using the hotplate. Westinghouse WFE547SA, WFE642SA, WFE619SA, WFE647WA

USING THE GAS COOKER

Gas hotplate

Ensure burner caps, crowns and trivets are properly assembled.

Burner Cap

Burner Cap

Spark Plug

Burner Crown

Thermocouple

Spark Plug

Burner

Crown

Lighting gas hotplate, grill and oven

Electronic ignition (For models WFE616 and WFE619)

These hobs are fitted with mains powered electronic ignition.

When the appliance has been connected and the power is on, depressing any knob will release sparks to all burners. To light a burner, depress the corresponding knob and while continuing to depress knob turn anticlockwise to ‘HI’ position. The knob may be released once the flame is established, and turned further anticlockwise to reduce the flame height as desired.

Push button Ignition (For models WFG617)

Turn appropriate burner control knob to maximum and at the same time press the ignition switch.

Flame safeguard models (For models WFE616, WFE619,

WFG617)

Models with flame safeguard have the same ignition procedure as above but require the knob to continue to be depressed after flame is established for approximately 5 seconds. If the flame goes out when the knob is released, simply depress the knob again, this time holding it down with slightly more force for the same length of time.

WARNING

• Keep hands clear of burners when lighting.

• If burner does not light within 5 seconds, turn knob to ‘Off’ position, allow gas to disperse, then try lighting again.

• Burners MUST be operated between ‘HIGH’ and ‘LOW’ settings only.

Thermocouple

Gas oven burner flame

From a cold start the oven burner flame will be higher on the left hand-side. After reaching the set temperature, the flame will become even. This does not affect cooking results.

To conserve gas, place the pan centrally over the burner and adjust the flame so that it does not go past the edge of the cookware.

NOTE: In the absence of electrical power, carry out the ignition directly to the burner with a hand held ignition source.

Grill ignition (For models WFG617)

Turn Grill Control Knob onto maximum and at the same time press Electronic Ignition Switch. This burner also has flame failure, so it is required to depress the knob approximately

5 seconds after the flame is established. If the flame goes out when the knob is released, simply depress the knob again, this time holding it down with slightly more force for the same length of time.

Grill – in oven

Grill is electric and is operated by control knob only.

Oven ignition – electronic

Push and hold Oven Control Knob onto desired temperature and at the same time press the Electronic Ignition Switch.

Hold control knob in for 15 seconds after ignition.

10

USING THE GAS COOKER

Gas hotplates (Energy rating)

1

2

3 4

1 Medium heat burner (9.0 MJ/h)

Used for normal cooking and simmering with mid size cookware items.

2 High heat burner (12.7 MJ/h)

Used for fast heating with large size cookware items.

3 Intense heat wok burner (14.4 MJ/h)

Used for very fast heating with woks and other large size cook ware items. Use wok support provided when cooking with a wok.

4 Low heat burner (5.1 MJ/h)

Used for simmering and for use with small cookware items.

NOTE: Energy ratings above are for natural gas (NG) models.

To conserve gas, place the pan centrally over the burner and adjust the flame so that it does not go past the edge of the cookware.

NOTE: In the absence of electrical power, carry out the ignition directly to the burner with a hand held ignition source.

11

USING THE COOKER