advertisement
4
DANS01 – Installation Guide
Safety and Precautions
Environmental
The temperature and humidity ranges shown in the specifications for this product must not be exceeded.
This equipment must not be installed in an area that is subject to a corrosive atmosphere.
When installed in accordance to the instructions in this document, the unit provides IP65 ingress protection.
ESD Precautions
This product contains static-sensitive devices. Observe
ESD precautions when working on the equipment with the cover removed.
Electrical Safety
Always replace blown fuses in the supply to this equipment with the correct type and rating. Ensure power supply cabling is adequately rated.
Unpacking and Handling
The equipment should be unpacked and inspected immediately on receipt. If damage has occurred please advise your carrier or supplier.
!
!
This equipment contains electronic devices that are sensitive to electrostatic discharge. Please take precautions to avoid damage to the electronics by static electricity.
It is advisable to retain the original equipment packing in the event that the equipment ever needs returning for service.
Ensure that the name and address of the Authorised
Distributor from whom you purchased the unit is recorded on the “
page of this manual for future reference.
Packing for Return for Repair
!
!
All electronics assemblies must be properly packed in ESD protective packing for transport, to prevent physical and ESD damage.
!
!
The filler material used for packing for return for repair must be antistatic or static dissipative, as this may come into contact with exposed connectors, wiring, or PCB assemblies. The use of nonconductive filler material may cause damage to the electronic assemblies reducing their operational life, or even destroying them.
Advice on packing the product for return can be provided by ASL.
Issue: 02 complete, approved
Page 11 of 12
Service and Warranty
Name and Address of Authorised Distributor:
This product carries a full warranty. For full details of warranty and service agreements, please contact the Authorised
Distributor who supplied the product to you.
Exclusions
The warranty does NOT cover:
1. Customer misuse, including incorrect installation.
2. Damage other than manufacturing defects.
3. Transit / Courier damage.
4. Incorrect voltage or power supply used.
5. Incorrect input signal.
6. Abnormal environmental operating conditions.
7. Damage incurred by accident, fire, lightning or other hazard.
8. Modification to the unit or inexpert / attempted repair.
9. No fault found – where no fault can be found after extensive testing, indicating user error or failure in ancillary equipment.
10. Electronic assemblies which are improperly packed when returned for repair or service. All electronics assemblies must be properly packed in ESD protective packing for transport to prevent physical and ESD damage.
Should any of the above apply, Application Solutions (Safety and Security) Limited reserves the right to raise any relevant charges to the customer.
Application Solutions (Safety and Security) Limited shall not be liable for any indirect, special or consequential loss or damage
(including without limitation any loss of profits) arising from the use of this product or for any breach of this warranty.
In the interest of continual product development, Application Solutions (Safety and Security) Limited reserves the right to make changes to product specification without notice or liability.
advertisement