SIM8X60 Serial EVB User Guidelines Manual
5Appendix
5.1 Related Documents
Table 39:Related documents
No.
Title
[1]
[2]
[3]
[4]
[5]
SIM8200 Series_AT Command Manual
SIM8260 serial Hardware Design
SIM8260 Serial
LGA Antenna Port Mapping and Design
Guide
SIM8200 Series PM7250B_design_guidel ines_V1.00
W82_Hardware Design_V1.00
Description
AT command manual
SIM8260 serial hardware design
SIM8260 Serial Antenna document
SIM8200 Series PM7250Bdesignguidelines
W82Hardware Design www.simcom.com
61 / 63
SIM8X60 Serial EVB User Guidelines Manual
5.2 Terms and Abbreviations
Table 40:Terms and abbreviations
Abbreviation Description
EMC Electromagnetic Compatibility
PCB
PCIe
RF
SIM
SMPS
NC
NMEA
ZIF
(U)SIM
UART
ESD
GNSS
GPS
I2C
I2S
IMEI
LTE
MSB
Electrostatic Discharge
Global Navigation Satellite System
Global Positioning System
Inter-Integrated Circuit
Inter-IC Sound
International Mobile Equipment Identity
Long Term Evolution
Most Significant Bit
Printed Circuit Board
Peripheral Component Interface Express
Radio Frequency
Subscriber Identification Module
Switched-Mode Power Supply
Not connect
National Marine Electronics Association
Zero Intermediate Frequency
Universal Subscriber Identity Module
Universal Asynchronous Receiver Transmitter www.simcom.com
62 / 63
SIM8X60 Serial EVB User Guidelines Manual
5.3 Safety Caution
Table 41:Safety caution
Marks Requirements
When in a hospital or other health care facility, observe the restrictions about the use of mobiles. Switch the cellular terminal or mobile off, medical equipment may be sensitive and not operate normally due to RF energy interference.
Switch off the cellular terminal or mobile before boarding an aircraft. Make sure it is switched off. The operation of wireless appliances in an aircraft is forbidden to prevent interference with communication systems. Forgetting to think much of these instructions may impact the flight safety, or offend local legal action, or both.
Do not operate the cellular terminal or mobile in the presence of flammable gases or fumes. Switch off the cellular terminal when you are near petrol stations, fuel depots, chemical plants or where blasting operations are in progress. Operation of any electrical equipment in potentially explosive atmospheres can constitute a safety hazard.
Your cellular terminal or mobile receives and transmits radio frequency energy while switched on. RF interference can occur if it is used close to TV sets, radios, computers or other electric equipment.
Road safety comes first! Do not use a hand-held cellular terminal or mobile when driving a vehicle, unless it is securely mounted in a holder for hands free operation.
Before making a call with a hand-held terminal or mobile, park the vehicle.
GSM cellular terminals or mobiles operate over radio frequency signals and cellular networks and cannot be guaranteed to connect in all conditions, especially with a mobile fee or an invalid SIM card. While you are in this condition and need emergent help, please remember to use emergency calls. In order to make or receive calls, the cellular terminal or mobile must be switched on and in a service area with adequate cellular signal strength.
Some networks do not allow for emergency call if certain network services or phone features are in use (e.g. lock functions, fixed dialing etc.). You may have to deactivate those features before you can make an emergency call.
Also, some networks require that a valid SIM card be properly inserted in the cellular terminal or mobile.
www.simcom.com
63 / 63
