1.3 Safety. Rotax 912 S, 912 UL, 912 ULS, 912 ULSFR, 912 F, 912 A

1.3) Safety

Revisions

Measurement

Symbols used

Although reading such information does not eliminate any hazards, it promotes understanding, and applying the information will promote correct use of the engine. Always apply common workshop safety rules.

The information and descriptions of components and systems contained in this Manual are correct at the time of publication.

BRP-Rotax maintains a policy of continuous improvement of its products without imposing upon itself any obligation to retrofit products previously manufactured.

BRP-Rotax reserves the right to remove, replace or discontinue any design, specification, feature or other at any time, and without incurring obligation.

Specifications are given in the SI metric system with the imperial and US customary measurement system equivalents in parenthesis.

This Manual uses the following symbols to emphasize particular information. This information is important and must be observed.

m WARNING

Identifies an instruction which, if not followed, may cause serious injury or even fatal injury.

m CAUTION

Identifies an instruction which, if not followed, may cause minor or moderate injury.

NOTICE

Identifies an instruction which, if not followed, may severely damage the engine or could void any warranty.

NOTE

Indicates supplementary information which may be needed to fully complete or understand an instruction.

Page 1-8

Ed.4/January 01 2023

BRP-Rotax Effectivity: 912 Series

Rev. 1

ENVIRONMENTAL NOTE

Environmental notes give you tips on environmental protection.

A revision bar outside the page margin indicates a change to text or graphic.

Effectivity: 912 Series

Rev. 1

BRP-Rotax

Page 1-9

Ed.4/January 01 2023