- Home
- Domestic appliances
- Small kitchen appliances
- Kitchen scales
- Invacare
- Reliant 600 RPL600-2
- User manual
Installing the Reliant Scale. Invacare R110, R117, R100, R102, Low Profile RPL600-2, Reliant 450 RPL450-2, R121, Low Profile RPL450-2, Reliant 600 RPL600-2
Add to my manuals52 Pages
advertisement
11 ACCESSORIES
Installing the Reliant Scale
For this procedure, refer to FIGURE 11.2.
WARNING
Patient and sling MUST be removed from the lift during ALL installation procedures.
1.
Use 1/4-inch nylon washer.
2.
Secure the Reliant Scale to the boom mounting bracket with a shoulder bolt, two nylon washers and a locknut. Securely tighten. Refer to Detail
“A” in FIGURE 11.2 for washer orientation.
Ensure the shaft of the shoulder bolt passes through both sides of the boom mounting bracket.
3.
4.
5.
Secure hangar bar pin to the load cell assembly with the provided mounting screw and locknut. Securely tighten. Refer to Detail “B” in
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may occur.
6.
Weigh the patient. Refer to Operating the Scale on page 46
and Weighing the Patient on page 47.
Electric Portable Patient Lift
44
DETAIL “A”
Boom
Locknut
Boom
Mounting
Bracket
Nylon
Washer
Reliant
Scale
Reliant
Scale
Mounting
Screw
11 ACCESSORIES
DETAIL “B”
Shoulder
Bolt
Nylon
Washer
Nylon
Washers
Load Cell
Assembly
FIGURE
11.2
Locknut
Hangar Bar
Hangar Bar Pin
45
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 5 Symbols
- 5 Warnings
- 6 Limited Warranty
- 7 General Guidelines
- 7 Operating Information
- 7 General
- 8 Pinch Points and Positioning
- 8 Assembling the Lift
- 8 Operating the Lift
- 9 Using the Sling
- 9 Lifting the Patient
- 10 Transferring the Patient
- 10 Performing Maintenance
- 11 Electrical and Grounding
- 11 Disposal
- 11 Radio Frequency Interference
- 13 Patient Lift
- 14 Full Body, Divided Leg and Toileting Slings
- 14 Reliant Scale RLS
- 15 Introduction
- 15 Unpacking the Patient Lift
- 16 Assembling the Mast to the Base
- 17 Assembling the Boom Actuator
- 18 Installing the Leg Actuator to the Base
- 19 Mounting the Battery Charger
- 20 Introduction
- 20 Using the Hand Control Buttons
- 20 Raising/Lowering the Boom
- 20 Opening/Closing the Legs
- 21 Activating a Mechanical Emergency Release
- 22 Performing an Emergency Stop
- 23 Charging the Battery
- 24 Introduction
- 24 Positioning the Patient Lift
- 25 Attaching a Sling
- 26 Lifting/Moving the Patient
- 28 Introduction
- 29 Transferring to a Commode Chair
- 30 Transferring to a Standard Commode
- 30 Transferring to a Bathing Unit
- 31 Transferring to a Wheelchair
- 33 Maintenance Safety Inspection Checklist
- 35 Lubricating the Lift
- 36 Detecting Wear and Damage
- 36 Cleaning the Sling and the Lift
- 36 Replacing the Boom Actuator
- 37 Checking and Tightening Mast Pivot Bolt
- 38 Replacing the Hanger bar
- 39 Maintaining the Base Adjustment
- 40 Replacing Casters/Forks
- 40 Replacing Rear Casters
- 41 Replacing Front Casters
- 41 Replacing Forks
- 42 Reliant Scale RLS
- 42 Removing the Hanger bar
- 44 Installing the Reliant Scale
- 46 Operating the Scale
- 46 Keypad Functions
- 47 Weighing the Patient
- 48 Replacing the Battery
- 49 Calibrating the Reliant Scale
- 50 Troubleshooting
- 50 Display Codes