advertisement
Chapter 4 — Configuration Command Reference
Configuration Modes and Utilities
Command
Configuration modes and utilities
Bluetooth device page
Default Value
Configuration
Enabled
N/A
See Page
40
37
SF51 Configuration Commands
This section lists the configuration commands in alphabetical order and provides a description of each command. To configure your SF51 using these commands, see the EasySet software.
Administrator Reset Factory Defaults
Causes the SF51 to perform a restart and restores all configuration commands to their default settings. When you restore all configuration commands to their default settings, you need to reestablish Bluetooth communications.
Beep Duration
Sets the length of the beeps. You can set Beep Duration to a value from 0 to 2550 ms. When Beep Duration is set to 0 ms, the beeper is off. Turning off the beeper does not affect the beeps associated with Bluetooth Connect/Disconnect or
Bluetooth Device Page.
Use Beep Duration in combination with Beep Frequency and
Beep Volume to define beeps according to operator preference and work environment.
Beep Frequency
Sets the frequency, or pitch, of the beeps. You can set Beep
Frequency to a value from 1000 to 5110 Hz.
36 SF51 Cordless Scanner User’s Guide
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 16 Charging the Battery
- 16 Checking the Battery Status
- 24 Configuring With EasySet
- 25 Configuring From Your Intermec Computer
- 26 Restoring Default Settings
- 27 Configuring Security
- 28 Configuring the Discoverable State of the SF51
- 36 Getting Information About Your SF51
- 37 Problems and Possible Solutions
- 48 Administrator Reset Factory Defaults
- 48 Beep Duration
- 48 Beep Frequency
- 49 Beep Volume
- 49 Bluetooth Connect/Disconnect
- 49 Bluetooth Device Name
- 49 Bluetooth Device Page
- 50 Bluetooth Discoverable
- 50 Bluetooth PIN
- 50 Bluetooth Profile
- 50 Bluetooth Security
- 51 Codabar
- 51 Codablock A
- 51 Codablock F
- 51 Code 11
- 51 Code 39
- 52 Code 93/93i
- 52 Code 128 / EAN 128
- 52 ISBT 128
- 52 GTIN Processing for EAN 128
- 52 Configuration Modes and Utilities
- 53 Consecutive Same Read Data Validation
- 53 Disable All Symbologies
- 53 Error Beep
- 53 Good Read Beep Duration
- 53 Good Read Beep Number
- 54 Good Read Beep Timing
- 54 Good Read LED Duration
- 54 Interleaved 2 of 5
- 54 Matrix 2 of 5
- 54 Micro PDF417
- 54 MSI
- 55 PDF417
- 55 Plessey
- 55 Postamble
- 55 Preamble
- 56 RSS 14
- 56 RSS Expanded
- 56 RSS Limited
- 56 Setup Beep
- 56 Stacked Code Crackle
- 56 Standard 2 of 5
- 57 Symbology Identifier
- 57 Telepen
- 57 Timeout Between Different Consecutive Codes
- 58 Timeout Between Identical Consecutive Codes
- 58 Trigger Mode
- 59 UPC/EAN
- 59 ISBN
- 59 GTIN Processing
- 59 User Reset Factory Defaults
- 59 Vibrate Alert
- 59 Vibrate Alert Duration