S2 NetVR Hardware Installation Guide

Using Revert Button to Reset IP Address and Login

Settings

To use the Revert button to reset controller IP address and login settings for NetBox VR or Pronto VR:

1.

Press the Revert button (shown in Figure 8) and hold it for a minimum of

three seconds.

After 15 to 30 seconds, the system will beep three times. This indicates that the controller settings have been reset.

2. To log into the security application, point your browser to the default controller IP address: 192.168.0.250.

Note: The Power and Reset buttons shown in Figure 8 can be used in the

following ways:

When the system is up and running, holding down the Power button for four seconds or longer causes a shutdown of the system, which is equivalent to unplugging it. Holding down the button for fewer than four seconds causes the LED to blink and shuts down the system in an orderly manner.

When the system is not running, pressing the Power button starts the system.

Pressing the Reset button causes an orderly power reset of the system.

S2 Security Corporation 16 June 2012