PRIMERGY TX120 S2 - Fujitsu Technology Solutions

4 Preparation

V

CAUTION!

Please note the safety instructions in

chapter “Safety” on page 13 .

4.1

Opening the server

Ê

Exit all applications and shut down the server properly.

Ê

Press the On/Off button if the server has not been switched off by the operating system.

Ê Unplug all power plugs.

Ê

Disconnect all cables on the rear of the server.

3

1

2

Figure 2: Opening the server

Ê Remove the stabilizers from the server (see operating manual) and place the server on its four rubber feet (1), if the server is operated in the vertical position.

Ê Press and hold in the locks on both sides of the server (2), push the top cover forwards and lift it up and off (3).

TX120 S2

Options Guide 19