advertisement
English / USA
Mounting the Loop Handle
1
1
2
4
2
A
3
5
50 mm
( 2" )
Check wear limit marks at regular intervals.
Wear limit marks are incorporated in the base of the PolyCut.
Stop using your PolyCut 5-3 immediately if one of the round holes
(1; arrow) becomes visible, or if the
upright rim (2; arrow) is worn as shown.
Install a new mowing head.
It is essential to observe the wear limit marks since there is otherwise a risk of the cutting tool shattering.
Thrown parts may result in personal injury.
: Fit the loop handle (1) on the drive tube, 5,9“ (15 cm) forward of the control handle (2).
: Fit clamp (3) against drive tube and slide it into the loop handle.
: Insert the square nut (4) in the loop handle.
: Fit the clamp screw (5) from the other side and t ighten down firmly.
Adjusting loop handle to most comfortable position
: Loosen the clamp screw (5).
: Slide the loop handle along the drive tube as required.
: Retighten the clamp screw.
14
FS 75
advertisement
Related manuals
advertisement
Table of contents
- 2 Contents
- 3 Guide to Using this Manual
- 4 Safety Precautions and Working Techniques
- 15 Mounting the Loop Handle
- 16 Fitting the Carrying Eye*
- 16 Mounting the Deflector
- 16 Mounting the Cutting Tools
- 19 Fuel
- 20 Fueling
- 21 Fitting the Harness
- 21 Starting / Stopping the Engine
- 24 Operating Instructions
- 24 Cleaning the Air Filter
- 25 Motor Management
- 25 Adjusting the Carburetor
- 27 Spark Arresting Screen* in Muffler
- 27 Checking the Spark Plug
- 28 Replacing the Starter Rope and Rewind Spring
- 31 Storing the Machine
- 31 Replacing Nylon Line
- 33 Maintenance Chart
- 34 Parts and Controls
- 36 Specifications
- 37 Special Accessories
- 37 Maintenance and Repairs
- 38 STIHL Incorporated Federal and California Emission Control Warranty Statement