US_XX. Sices GATEWAY Modbus/TCP

The GATEWAY Modbus/TCP is a compact device designed to enable serial port communication within an Ethernet network. It supports the Modbus protocol in RTU mode for serial communication and Modbus/TCP for Ethernet communication, acting as a gateway between the two. This device can be used to connect various devices with serial ports to an Ethernet network, allowing for remote monitoring and control of these devices.

PDF
Document
GATEWAY Modbus/TCP User Manual | Manualzz

Advertisement

Advertisement

/

Advertisement

Key features

  • Supports serial port communication with Modbus RTU

  • Converts Modbus/RTU messages to Modbus/TCP and vice versa

  • Provides Ethernet connectivity for serial devices

  • Supports up to four simultaneous connections

  • Includes four digital inputs and four digital outputs

  • Comes with PC configuration software for easy setup

  • Supports RS-232 and RS-485 serial standards

  • Offers automatic anomaly detection and reporting via Ethernet

  • Allows for configuration of device addresses and types for automatic scanning

  • Provides network gateway IP address configuration for separate networks

Frequently asked questions

The GATEWAY Modbus/TCP acts as a bridge between serial devices using the Modbus RTU protocol and an Ethernet network, allowing for remote communication and control.

Yes, the GATEWAY Modbus/TCP supports multiple devices on the serial port, but they must be slaves in the communication, meaning they only respond to queries and don't initiate transmissions.

These inputs and outputs can be used for various purposes, such as monitoring device status, triggering events, or controlling external devices.

The network interface can manage a maximum speed of 10 Megabits per second, but it can also work with a 100 megabits per second network using a hub or switch that supports both speeds.

You can use the provided PC configuration software to set up the device's IP address, subnet mask, TCP port, and other settings, either through the serial port or Ethernet connection.

No, the GATEWAY Modbus/TCP does not support the DHCP protocol for automatic IP address assignment. You need to manually assign a static IP address to the device.

Preparing document for printing…
0%