EXTERNAL COM. CMIS. Electrolux W5 585S, W5 5105S, W5 5130S, W5 5180S, W5 5250S, W5 5330S, W5 575S
W5 575S, W5 585S, W5 5105S, W5 5130S, W5 5180S, W5 5250S, W5 5330S are washers with a wide range of functions, from washing and spinning to drying. All models have a built-in motor control unit and a central control system for easy operation. They are equipped with various sensors to monitor water temperature and level. The unit also features a detergent container for both liquid and powder detergent.
Advertisement
Advertisement
Advertisement
Key features
Large drum capacity
Powerful spin cycles
Variety of wash programs
Durable construction
Frequently asked questions
Disconnect the power to the machine. Demount the front panel. Remove the cover to the heating elements. Loosen the hose clamps and demount the hoses from the drain valve. Remove the hose from the valve’s nipple for water supply. Loosen and unscrew the four retaining nuts of the valve a couple of turns. Turn the valve and unlock it from the bolts. Mount the new drain valve and tighten the bolts. Mount the hoses. Tighten the hose clamps. Mount the cover to the heating elements. Mount the front panel.
Disconnect the power to the machine. Demount the rear panel. Remove the belt and put the new belt in position. The belt tension should be according to the table, adjust if necessary. Remount the rear panel. Connect the power to the machine.
Disconnect the power to the machine. Demount the back panel. Demount the drain and hoses to the drum. Demount the air hose and the hose from the detergent compartment on top of the drum. Remove the belt. Demount the anti-rotationpanel. Unscrew the screws to the tension strap. Remove the screws in the on the side panels. Tilt the cabinet backwards a little bit so it is possible to pull out the drum. Carefully pull out the drum. Mount the new drum. Fasten the tension strap. Fasten the screws to the cabinet. Mount the anti-rotationpanel. Fasten the belt. Make sure the belt is in position. Check the belt tension. Mount the drain and hoses to the drum. Mount the air hose and the hose from the detergent compartment on top of the drum. Remount the back panel. Connect the power to the machine.
Disconnect the power to the machine. Demount the rear panel. Remove the belt. Demount the cover panel to the motor cable. Disconnect the motor cable and unscrew the earth screw. Demount the motor. Mount the new motor. Connect the motor cable and refit the earth screw. Mount the cover panel to the motor cable. Fasten the belt. Make sure the belt is in position. Check the belt tension. Mount the rear panel.
Disconnect the power to the machine. Demount the front panel. Remove the cover to the heating elements. Disconnect the connectors to the heating elements. Loosen the bolt to the heating element and gently push on the middle of the heating element to release the flange. Remove the heating element and insert the new heating element. Push on the middle of the heating element to get the flange in position. Fasten the bolt. Use tightening torque 6 Nm. Reconnect the connectors to the heating element, use the electric schematic supplied with the machine.