advertisement
COMPONENT ACCESS
!
WARNING
• DISCONNET power supply cord from the outlet before servicing.
• Replace all panels and parts before operating.
• RECONNECT all grounding devices.
- Failure to do so can result in severe personal injury, death or electrical shock.
!
CAUTION
• Be careful when you work on the electric range handling the sheet metal part.
- Sharp edge may be present and you can cut yourself.
1. Open the oven door to its fully down position.
2. Pull the oven door gasket clips out of the liner holes until all of the clips are removed.
3. Pull the ends of the gasket out of the liner holes.
Liner Hole
REASSEMBLY NOTE: When you install the new gasket, make sure that all of the clips are seated in their liner holes, and that the ends of the gasket are pushed fully into their holes. Use the pointed end of a pencil to push the gasket ends into the holes.
3-16
advertisement
Related manuals
advertisement
Table of contents
- 29 GENERAL
- 29 • Important safety instructions
- 29 • Model & Serial number label and tech sheet locations
- 29 • Specifications
- 30 THEORY OF OPERATION
- 30 • General imformation
- 30 • Control panel features
- 31 COMPONENT ACCESS
- 31 • Component Locations
- 31 • Removing the Back, Control Cover and Key Membrane, Support Assembly
- 31 • Removeing the Control Power Swpply and Power Control Board (PCB)
- 31 • Removing the Surface Element and the Ceramic Glass Cooktop
- 31 • Removing the BROIL element
- 31 • Removing the BAKE element
- 31 • Removing the CONVECTION element, Fan blade and Fan motor
- 31 • Removing the Oven light & Socket assembly
- 31 • Removing the latch drive assembly
- 31 - Door locking mechanism
- 31 • Removing the Oven temperature Sensor
- 31 • Removing the Warming drawer element & temperature sensor
- 31 • Removing & Replacing the Lift-off Oven Door
- 31 • Removing the Oven Door Handle & Glass
- 31 • Removing the Oven Door Gasket
- 31 • Removing a Side Panel