Invacare
®
- Bora/Spectra XTR
9.2.1 Standard seat
Requirements:
· 4 mm Allen wrench
· 5 mm Allen wrench
· 13 mm open-ended wrench
· Flat screwdriver
· Smal hammer
WARNING: Danger of crushing!
The seat is very heavy. Danger of injury to hands and feet!
· Pay attention to the hand and feet.
· Use proper lifting techniques.
The pictures show the standard seat without seat covering from above (A) and below (B).
SERVICE MANUAL
· Rear bolts (1)
· Front bolts (2)
· Seat plate (3)
· Seat frame (4)
The seat plate can be fixed in three different positions on the seat frame.
· Front fixing (V)
· Centre fixing (M)
· Rear fixing (H)
127
SERVICE MANUAL
The picture shows where the drillholes for fixing the seat frame (3) are located on the base frame.
· Rear drillholes (1)
· Front bolts (2)
The seat frame can only be fixed in one position on the base frame.
Invacare
®
- Bora/Spectra XTR
The picture shows the seat frame with the drillholes for the standard seat.
· Rear drillholes (1)
· Front drillholes (2)
128
