advertisement
while (1) {
int res;
char buf[255];
SetDis();
ReadKey(); /* sub-routine to send "read key" command */
res = read(fd,buf,255); /* read response from EZIO */
switch(buf[1]) { /* Switch the Read command */ case 0x4D :
Cls();
/* Up Botton was received */
ShowMessage(mes1,mes3); /** display "Portwell EZIO" */
break; /** display "Up is selected */
case 0x47 :
Cls();
/** Down Botton was received */
ShowMessage(mes1,mes4); /** display "Portwell EZIO" */
break; /** display "Down is selected" */
case 0x4B :
Cls();
/** Enter Botton was received */
ShowMessage(mes1,mes5); /** display "Portwell EZIO" */
break; /** display "Enter is selected" */
case 0x4E :
Cls();
/** Escape Botton was received */
ShowMessage(mes1,mes6); /** display "Portwell EZIO" */
break; /** display "Escape is selected */
}
}
}
Chapter 3 Operation Guide
3.1 Brief Guide of PPAP-3714L
PPAP-3714L is an Intel®Pentium
™
4 based board with Cavium Nitrox Lite CN1010X supporting
IPSec/SSL. The onboard Cavium security processor provides a cost advantage and the flexibility to implement various networking appliances. The PPAP-3714L has the capability of processing up 1GB IPSec traffic or 7000 RSA operations per second.
PPAP-3714L is a Communication Appliance computing board based on Intel 875P chipset technology. PPAP-3714L has ten on-board LAN ports to serve communication appliances, such as Firewall, which needs sufficient ethernet ports to connect external network (internet), demilitarized zone and internal network. Different I/O management policies can be applied respectively to individual network to achieve the highest security level. The target market segment is communication appliance including Virtual Private Network, Load Balancing, Quality of Service, Intrusion Detection, Virus Detection, Firewall and Voice Over IP.
This PPAP-3714L system board is utilized with Intel® mPGA Celeron® and Intel® mPGA
Pentium® 4 processors, and 184-pin DIMM. The enhanced on-board PCI IDE interface supports
2 drives up to PIO mode 4 timing and Ultra DMA/100 synchronous mode feature. The on-board
NAR-5100 User’s Manual
50
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 3 About This Manual
- 3 Manual Organization
- 3 Technical Support Information
- 5 Included Hardware
- 5 Before You Begin
- 6 The Chassis
- 6 Open the Chassis
- 7 Remove and Install DIMM
- 7 Remove and Install Compact Flash Card
- 8 Remove and Install Battery
- 8 Install HDD
- 9 Ear Mount Kit Installation
- 10 Product Specifications
- 10 Hardware Configuration Setting
- 13 Install a Different Processor
- 15 BIOS Setup Information
- 21 Reset to Default Information
- 30 WDT Information
- 33 GPIO Information
- 41 About EZIO
- 51 Brief Guide of PPAP-3714L
- 52 System Architecture