- No category
advertisement
BWS-T4 Series
Instruction Manual
8. DEVICE MAINTENANCE
SG-BWS-T4 and photocells of the S5, SL5, S300 series do not require any special servicing.
To avoid the reduction of the operative distance, optics protective front surfaces shall be cleaned at regular intervals.
To this end, use soft cotton cloths damped in water; do not apply too much pressure onto the surface so as not to make it dull.
Please do not use on plastic surfaces or optics:
alcohol or solvents
wool or synthetic cloths
paper or other abrasive materials
Under current Italian and European laws, Datalogic Automation is not obliged to take care of product disposal at the end of its useful life.
Datalogic Automation recommends to dispose of the product in compliance with local laws or contact authorised waste collection centres.
26
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 5 GENERAL INFORMATION
- 5 Purpose of this document
- 5 Intended readers
- 5 Usage information
- 6 PRODUCT GENERAL DESCRIPTION
- 6 Package Content
- 6 Products components and interface
- 7 Safety sensors
- 7 Main functions managed by the control unit
- 8 Typical Applications
- 9 INSTALLATION
- 9 Safety information
- 9 Precautions to be observed for the choice and installation of the device
- 9 General information on sensors positioning
- 9 Minimum installation distance
- 11 Minimum distance from reflecting surfaces
- 12 Sensors Interference
- 13 Installing the safety control unit
- 13 Installing the sensors
- 15 ELECTRICAL CONNECTION
- 15 Important installation tips
- 15 External relays connection for machine control
- 16 Minimum connections (1 photocell, no EDM, automatic restart)
- 17 Complete list of connections
- 18 Connecting the safety photocells
- 19 Connecting the external relays and EDM
- 20 Reset mode and connection of the Start/Test/Reset push-button
- 22 COMMISSIONING
- 22 Screen indications upon switch-on
- 22 Safety devices alignment
- 23 DIAGNOSTICS AND WARNINGS
- 23 Normal operation signalling
- 24 Failure state signalling
- 25 PERIODICAL CHECKS AND WARRANTY
- 25 Periodical checks
- 25 Warranty
- 26 DEVICE MAINTENANCE
- 26 Product disposal
- 27 TECHNICAL DATA
- 28 ORDER DATA
- 30 OVERALL DIMENSIONS
- 30 SG-BWS-T
- 30 S5-ST2,S5-ST4, SL5-ST4, S
- 31 APPENDIX
- 31 FIGURE INDEX
- 31 TABLES INDEX