advertisement
6. Network Configuration
A. Intranet Only
Connects to PC Directly
If you want to connect the camera to PC directly for the very first time setup, please refer to the figure below for the connection.
Camera
IP Address: 192.168.1.200
Subnet Mask: 255.255.255.0
Gateway: (Empty)
Http Port: 80
RTSP Port: 554
Ethernet Cable
This device supports Auto-MDI/MDIX, you can use a straight or cross-over cable to connect these two devices.
PC
IP Address: 192.168.1.2
Subnet Mask: 255.255.255.0
Gateway: (Empty)
Connect the camera to PC with Ethernet cable. The camera equips an
Auto-MDI/MDIX network connector, you can use a straight or cross-over Ethernet cable.
page to configure the IP settings.
Please make sure the IP address of PC and camera are in the same subnet. Ex.
192.168.1
.2 and 192.168.1
.200 have the same subnet.
Set Subnet Mask of PC and camera.
Clear the Gateway of PC and camera to empty.
For example, if the IP settings have been configured as the above figure, the cameras can be linked with following addresses:
Client Camera
PC Camera
Link Address
http://192.168.1.200
Remark
73
advertisement
Related manuals
advertisement
Table of contents
- 8 Cable Connections
- 10 I/O Connections
- 18 System Information
- 22 User Management
- 24 System Upgrade
- 25 System Logs
- 26 Video Format
- 32 Image Setting
- 35 Audio Setting
- 37 Network Setting
- 42 Wireless Setting
- 45 Mail / FTP / Samba Setting
- 49 PPPoE / DDNS Setting
- 52 HTTPS Setting
- 54 SNMP Setting
- 56 IP Filter Setting
- 58 QoS/ DSCP Setting
- 59 IEEE 802.1x Setting
- 60 Event Setting
- 67 I/O Setting
- 69 Schedule
- 71 Micro-SD Card
- 74 Connects to PC Directly
- 75 Connects to an Exist LAN
- 76 Connects to ADSL with Fixed Public IP Address
- 77 Connects to ADSL with Floating Public IP Address (PPPoE)
- 79 Connects to Internet with Fixed Public IP Address
- 81 Connects to Internet with Floating Public IP Address