For KEIL MDK ARM with ULINK2

User Manual: LPC1768-Xplorer

2.0 LPC1768-Xplorer Development Tool Setup

2.1 IDE and debugger

As mentioned in the earlier section, NGX’s MCU evaluation platforms are not coupled tightly with any one particular combination of IDE and debugger. The following sections will explain the setup for KEIL and ULINK2 as the IDE and debugger respectively.

2.2 Installation & Configuration of KEIL software

The Installation of KEIL software is explained below:

Step 1: Open the KEIL setup

Fig.2

5 www.ngxtechnologies.com

User Manual: LPC1768-Xplorer

Step 2: Click on Next.

Fig.3

Step 3: Select Terms & conditions check box and click on Next

Fig.4

6 www.ngxtechnologies.com

User Manual: LPC1768-Xplorer

Step 4: Provide the destination path and Click on Next

Fig.5

Step 5: Fill your Personal information and Click on Next

Fig.6

7 www.ngxtechnologies.com

User Manual: LPC1768-Xplorer

Step 6: Click on Next

Fig.7

Step 7: Keil µVision4.23 setup is completed. Click on Finish.

Fig.8

8 www.ngxtechnologies.com