- Sports & recreation
- Camping, tourism & outdoor
- Camping, tourism & outdoor cookware
- Cool boxes
- User manual
advertisement
86
Hint Hint
• Gases in red have either too high or too low ppO2 to be used in the current depth (They can be selected by the user, anyway).
For a planned gas change the gas that should be used in the current depth is highlighted and can be found quite simply.
• Gases in blue are disabled. (They can be selected by the user anyway).
A gas will be highlighted in yellow if the current depth is 0-3m higher then the configured change depth of this gas.
Setpoint change
Set Gas
Available in Open Circuit, Closed Circuit,
Gauge
Press ENTER repeatedly (or hold-down the ENTER button) until the required value is displayed.
This setting allows you to select the currently used gas mix. You may choose between the presets made in Gas Setup
(in surface mode). Oxygen and Helium fractions of the current gas mix are displayed on the main display.
The new value is displayed in the first line, next to GAS:
To apply the new setting, select ENTER
In order to revert to the preset gas mix, select it again from the Gas List.
Select O2 + or O2 –, to increase or decrease the oxygen fraction.
Select He + oder He – to increase or decrease the helium fraction.
87
88
Bailout
SetPoint
For Closed Circuit
Choose between the five setpoints that have been configured in CCR Setup
(surface mode).
When O2 sensors are connected via the hwHUD the sensor readings can be used for the decompression calculations too.
Choose “CCR Sensor” to select the sensor readings as the input for the Bühlmann algorithm.
Bailout
For Closed Circuit
Select the current bailout gas mix. You can choose between five preset gas mixes already configured in OC Gas
Setup (surface mode). Oxygen and helium fraction of the current gas mix are displayed on the main screen.
89
advertisement
Related manuals
advertisement
Table of contents
- 10 Display
- 11 Planning
- 11 Record
- 14 Special Markings
- 14 Terms of Use
- 17 Plan your dive
- 20 Take a backup system with you
- 22 Do not modify the hardware
- 22 reach
- 28 Surface Mode
- 28 Dive Mode
- 30 Sleep Mode
- 32 calculation
- 33 decompression calculation
- 35 Display in Surfacemode
- 36 Desaturation diagram
- 38 Gaslist
- 39 Setpoints
- 40 Dive Setting Display
- 45 Logbook
- 45 Memory
- 47 Displaying details
- 48 OC Gas Setup
- 50 Setup Gas-Type
- 51 Setup Mix
- 52 Setting the operation depth
- 52 Examples
- 54 CCR Setup
- 54 CCR Mode
- 55 CCR Sensor
- 56 Diluent Setup
- 56 Setup Diluent Type
- 58 Fixed Setpoints
- 68 Alternative GF
- 70 Settings
- 72 Brightness
- 73 Units
- 74 Salinity
- 75 Language
- 78 Reboot
- 79 Reset Deco
- 79 Reset all
- 82 Menu in Dive mode
- 83 Decoplan
- 86 Set Gas
- 90 Reset Avr
- 90 Average depth
- 97 Spare parts