advertisement
Supported Resolution
If the SOURCE LED continues to blink in green (slower than “no signal” mode);
OSD display: , and there is no video displayed or the video quality suffers, it indicates that the video frame rate from your A/V source device is not supported. Ensure that the consumer timing of your HDMI device is compliant with the standard listed below:
2D Video Format Timings
Primary CEA Video Timing
Resolution
640x480p @ 59.94 / 60Hz
720x480p @ 59.94Hz
720x480p @ 60Hz
720x576p @ 50Hz
1280x720p @ 50Hz
1280x720p @ 59.94 / 60Hz
480p
576p
720p
1920x1080i @ 50Hz
1920x1080i @ 59.94 / 60Hz
1080i
1920x1080p @ 50Hz
1080p / 60
1920x1080p @ 59.94 / 60Hz
Secondary CEA Video Timing
1920x1080p @ 23.98 / 24Hz
1920x1080p @ 25Hz
1920x1080p @ 29.97 / 30Hz
1080p / 24
VESA Timing (DVI only)
640x480 @ 59.94 / 72.809Hz
800x600 @ 60.317 / 72.188Hz
1024x768 @ 60 / 70.069Hz
1280x768 @ 60 Hz
1280x1024 @ 60 Hz
VGA
SVGA
XGA
WXGA
SXGA
Support
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
YES
26
advertisement
Related manuals
advertisement
Table of contents
- 4 Important Information
- 8 Introduction
- 8 Package Contents
- 8 Requirements
- 9 Overview
- 12 Hardware Installation
- 12 Step 1: Setup the Transmitter
- 13 Step 2: Setup the Receiver
- 14 Step 3: Setup the IR blaster extender cable and IR sensor extender cable
- 15 Step 4: Mounting the Receiver to a Wall (Optional)
- 16 Basic Operation
- 22 Advanced Operation
- 22 Naming the Input Source Devices
- 23 Pairing new transmitter with existing receiver (optional)
- 24 Multiple Transmitter Selection
- 26 Supported Resolution
- 27 Audio Bit Rate Support
- 28 Specifications
- 29 Troubleshooting
- 31 Federal Communications Commission (FCC) Statement
- 31 Limited Warranty
- 31 Contact