- Computers & electronics
- Networking
- Network extenders
- CCOM
- NIC-EBS/L/V
- Installation and Operation Manual
advertisement
![Features. CCOM NIC-EBS/L/V | Manualzz Features. CCOM NIC-EBS/L/V | Manualzz](http://s1.manualzz.com/store/data/006635525_1-6607b731a15fa4055fc555d9177831fa-360x466.png)
NIC-EBS/L/V/i Installation and Operation Manual
1.4 Features
¾ Standard: IEEE 802.3, 802.3u, 802.1Q, 802.1x, ITU-T G.703, G.742, G.823
¾ Unframed Speed: 2048K Bit/s
¾
Support SNMP network management through central card unit fixed in NIC-iRACK
¾ E1 connector: 75Ω BNC/120Ω RJ-45
¾ Ethernet Interface: RJ-45 jack, 10 /100Base-T interface, auto MDI-X
¾ Auto negotiation or force mode on Full/Half Duplex mode and 10/100M speed
¾ Support VLAN trunk and flow control functions
¾
Loop test function: ANA, DIG, REM
¾ Power supply: 90~220VAC, -36~-72VDC, +18~+36VDC
¾ Card style or stand alone style
1.5 Physical Description
NIC-EBS/L/V/i is available as a standalone unit or as a rack-mount card for the NIC-iRACK.
1.5.1 Front Panel of Stand Alone Unit
Figure 1-2 Front Panel of Stand Alone Unit
The front panel includes 8 LEDs, which display the status of power, data flow, Ethernet link and E1 channel signal.
Four front-panel push-buttons control 3 kinds of loopbacks and the display of remote Ethernet interfaces. For detailed description of the front panel, see
Chapter 3
.
1.5.2 Rear Panel of Stand Alone Unit
CCOM Communication Technology Co.Ltd. Http://www.ccom.com.cn
Page 9 of 32
advertisement
Related manuals
advertisement
Table of contents
- 8 Chapter 1 Introduction
- 8 Overview
- 8 Versions
- 8 Applications
- 9 Features
- 9 Physical Description
- 10 Technical Specifications
- 15 Chapter 2 Installation and Setup
- 15 Site Requirements and Prerequisites
- 15 Configuration
- 17 Installation and Setup of Standalone Unit
- 20 Installation and Setup of Card Unit
- 21 Chapter 3 Operation
- 21 Front Panel Indicators and Controls
- 22 Operating Procedure
- 22 Loopback Test
- 25 SNMP Network Management