SPECIAL CONFIGURATIONS. Logic Controls KB3000

SPECIAL CONFIGURATIONS

The KB3000 can be set up with many different programming options. To activate the configuration menu screen the KB3 program must first be placed into the extended menu (Ctrl, Alt, F4). Press F3 to open the configuration screen. By depressing the highlighted letter in each option the program will enable or disable that option. The default settings are shown in the graphic below.

Send Break-codes for scan-codes

Enable beep while a key pressed

No beep if a key is undefined

Translate to code-set #2 for AT

Emulating XT keyboard always

Use ALT+num to generate ASCII

Enable Typematic for scan codes

Enable Typematic for ASCII codes

Emulating Link Terminal

InterCharacter Delay (+/-):

Enable RS232 Output

Baud Rate:

Parity:

Length of Data:

2

mS

No

9600

NONE

8

-bits

No

No

No

No

No

Yes

Yes

Yes

Yes

Press a High-light Letter to select

Esc ==> Quit from this menu

16

Send Break-code for scan-codes - Enables or disables the transmission of break codes for each scan code programmed into the keyboard.

Enable beep while a key pressed - Enables or disables the entire keyboard from beeping when any key is depressed.

No beep if a key is undefined - If a key is not programmed it will not beep when depressed.

Translate to code set #2 for AT - Enables or disables the output of the keyboard to be translated into AT scan code.

Emulating XT keyboard always - Enables or disables the output of the keyboard to be translated into XT scan code.

Use ALT +num to generate ASCII - Enables or disables the ability to use the ALT key along with the numeric keyboard to generate ASCII codes.

Enable typematic for scan codes - Enables or disables keys programmed with scan code information to repeat the programmed characters as long as the key remains depressed.

Enable typematic for ASCII codes - Enables or disables keys programmed with ASCII code information to repeat the programmed characters as long as the key remains depressed.

Emulating Link Terminal - Enables or disables the keyboards ability to emulate a link terminal.

Intercharacter Delay (+/-) - The time delay between characters can be adjusted from 1 millisecond to 266 milliseconds. This delay is set for all characters programmed into the keyboard. Do not confuse this feature with the inter-string delay feature.

17