Chapter 7: Accessories
Checking the items supplied
Check that the individual items supplied are complete and undamaged. You should have received:
• 1 feed rail
• 1 front paper stand
• 1 to 4 rear paper stands
Adjusting the length of the feed rail
You will need a cross-head screwdriver for this.
Remove the packing material. Keep the original packing material safe so that you can transport the sheet feeder safely at a later date if necessary.
The metal paper feed rail enables you to fit a narrow cut sheet feeder onto a wide printer. All that is required is to adjust the feed rail to the wide platen.
1.
Undo and remove the screws on the top of the feed rail.
Screws
2.
Lay the extension piece of the rail next to the appropriate holes so that they align on the right hand side.
7-2
