Sortfast. Robelle Suprtool 4.6.01, STExport, Suprlink

Suprtool 4.6 for HP-UX: Suprtool

If you start using a persistent redo stack, you might start running into concurrency problems. A persistent redo stack can only be used by one Suprtool instance at any one point in time. If you try to use a persistent redo stack that is already in use, you will get the following message:

>set redo myredo

The redo file is already in use.

Unable to open file for REDO stack

In this situation, Suprtool continues to use the redo stack active at the time and lets you continue to work as normal.

Qedit can also have permanent redo stacks. To prevent products from writing to each other's redo stack, it is advisable to have separate stacks for each product by giving them different file names. For example if you use

>set redo myredo you will have a redo stack called myredo for your Suprtool commands. If you exit

Suprtool and run Qedit and supply the same Set Redo command, your Qedit commands will be written to the same file that was used for your Suprtool commands.

Sortfast

SET SORTFAST ON | OFF

This command has no effect in Suprtool/UX.

Squeeze

SET SQUEEZE [ ON | OFF ]

This command has no effect in Suprtool/UX.

Statistics

SET STATISTICS ON | OFF

(Initially: OFF)

STATISTICS causes Suprtool to print statistics at the end of each task. This can be useful for determining the effectiveness of Suprtool's If and Sort command versus similar options on the Select command.

Subsystem

SET SUBSYSTEM ON | OFF

This command has no effect in Suprtool/UX.

Suspend

SET SUSPEND ON | OFF

This command has no effect in Suprtool/UX.

Suprtool Commands

• 167