INNHOLD

FRAME DESCRIPTIONS

23

FRAME 4, Time

Chosen by"

"

Actual time is displayed on the upper line while the time the cabinet shall stop is displayed on the lower line.

TIME NOW: 1 0 0 0 0

MINUTE: Minutes from 00 to 59

HOUR:Hours from 00 to 23

DAY: Days from 1 to 7

The day numbers runs from 1 to 7 so one cycle is exactly one week. It is important to enter correct time when the timer function is used. See description of frames 5-8, timer breakpoints.

STOPTIME: 0 0 0 0 0

MINUTE: Minutes from 00 to 59

HOUR:Hours from 00 to 23

DAY: Days from 1 to 7

With zeros only, as in this example, the cabinet will run continuously. If day, hour and minute is defined, the cabinet will stop when upper and lower line are equal.

At the same time the message "END OF CYCLE" appears on the lower line at frame 1 and the LED at

" " lits.

The temperature will still be displayed, while the data recording stops. All logged data are kept in the memory and will be cleared when the cabinet is restarted.

When the cycle is completed, the stop time is cleared.

Therefore, the cabinet will run continuously after the restart if not a new stop time is defined.

The cabinet is restarted by a hit on " " .

FRAME 5-8, Timer breakpoints

Chosen by "

"

The timer can be programmed at 4 equal frames: TA,TB,TC and TD.

Each of the frames contains 4 breakpoints.

The breakpoints refer to TIME NOW on frame 4.