2.13 Installing USB Driver . Geovision Surveillance system

2.13 Installing USB Driver

To use the USB function, it is required to install the driver on the PC. Follow these steps to install the driver:

1. Insert the software CD. It will run automatically and pop up a window.

GeoVision USB Devices Driver. This dialog box appears.

Figure 2-51

3. Click Install to install the drivers. When the installation is complete, this message will appear: Install done!

5. To verify the drivers are installed correctly, go to Device Manager. Expanding the

Ports field, you should see one entry for Prolific USB-to-Serial Bridge.

Figure 2-52

178

Chapter 3 Software Installation

This chapter includes the following information:

• Important notice

• Installing a program

• Program list