Set Command [S]
Enables or disables certain operating options within Suprtool. These options are not reset by Xeq or Reset commands.
SET ALLBASE ROWS number
SET
SET
SET
SET
ARITHMETIC CLASSIC|IEEE
BASECLOSE ON|OFF
BLOCKSIZE [size]
BUFFER [size]
SET
SET
SET
SET
SET
SET
SET
SET
SET
SET
SET
CLEANCHAR <string>
CURRENCYSYMBOL <string>
DATE CUTOFF [number]
DATE FORCECENTURY ON|OFF
DATE IFYY2000ERROR ON|OFF
DATE MAPTOPHDATE8 ON|OFF
DECIMALSYMBOL <string>
DEFER ON|OFF
DUMPONERROR ON|OFF
EOFREAD ON|OFF
FILECODE number
SET FILENAME Help|Link|Edit|Hint|Export|Outcount filename
SET FIRSTREC [0|1]
SET
SET
SET
SET
SET
SET
SET
SET
SET
SET
SET
SET
SET
SET
SET
HINTS ON|OFF
IFCHECK ON|OFF
IGNORE ON|OFF
ITEMABBREVIATEDATE ON|OFF
INTERACTIVE ON|OFF
ITEMLOCK <fieldname>
LABELLEDTAPEREWIND ON|OFF
LIMITS [Mpe ON|OFF] [ReadOnly ON|OFF] [Tablesize size]
LIST DATE number
LIST PCL [0|1|2|3|4|5|6]
LIST TIME number
LOCK [number]
NLS [number]
NUMBUG ON | OFF
OPENMODE [number]
244 • Suprtool 5.7 for MPE
Suprtool Commands
Add system-wide Set commands to the
Suprmgr.Pub.Sys configuration file.
Suprtool Commands
SET ORACLE ROWS number (not supported in Suprtool/MPE)
SET ORACLE INTEGER ON | OFF (not supported in Suprtool/MPE)
SET
SET
SET
SET
SET
SET
ORACLE OPENFIX ON|OFF (not supported in Suprtool/MPE)
ORACE ZERONULL ON | OFF (not supported in Suprtool/MPE)
PATTERN NEW|OLD
PREFETCH [number]
PRIVMODE ON|OFF
PROGRESS Percent [number] Minimum [number]
SET PROMPT character
SET REALMAP ON|OFF (has no effect in Suprtool/MPE)
SET RECOVER ON|OFF
SET REDO filename
SET
SET
SET
SET
SORTFAST ON|OFF
SQUEEZE [ON|OFF]
STATISTICS ON|OFF
SUBSYSTEM ON|OFF
SET SUSPEND ON|OFF
SET THOUSANDSYMBOL <string>
SET USERLABELS ON|OFF
SET VARSUB ON|OFF
SET
SET
SET
SET
VARSUBCOMPAT ON|OFF
VARSUBDEBUG ON|OFF
WARNINGS ON|OFF
XLTRIM ON|OFF
Each option is its own Set command. That is, you cannot specify multiple options in the same command. Instead, use multiple Set commands. For example, to Set
Squeeze Off and to define a PCL device for the List command, you would specify two Set commands:
>set squeeze off
>set list pcl 1 or
>set squeeze off;set list pcl 1
When Suprtool starts running, all the options are set to initial "factory settings". The
Suprmgr file may contain Set commands to override the initial values. Set commands remain set until the end of the Suprtool run, or until changed by another Set command.
Some commands have optional parameters (e.g., the numeric value of Set Lock). If the command is specified without a value, the default that Suprtool uses may be different from the program's initial value. When that is the case, the command description will show the initial value and the default-when-omitted value.
Suprtool 5.7 for MPE• 245
