Platform
Dbvisit Replicate runs on the following platforms:
• Microsoft Windows (2003, 2008, Windows 7)
• Linux (x86, AMD64, EMT64, x86_64)
• Solaris (SPARC, x86, AMD64, EMT64, x86_64)
• AIX
Dbvisit Replicate has a 32-bit and 64-bit version and comes prepackaged Oracle Instant Client, thus no separate Oracle client install is necessary.
Oracle versions from Oracle 9.2, 10g and 11g. Dbvisit Replicate works with Standard Edition (SE), Oracle
Enterprise Edition (EE), Workgroup Server, Standard Edition One and Oracle XE.
Exact supported version numbers are determined by the Oracle client support; for the 11.1 prepackaged
Instant Client, this is described in MOS note 207303.1. In short, it requires 9.2.0.4 or higher. (Solaris version for Intel/AMD uses 11.2 Instant Client, as no 11.1 version was published by Oracle Corporation.)
Dbvisit Replicate works with RAC. ASM, OMF and flash recovery area.
Dbvisit Replicate supports heterogeneous configurations, i.e. the processes can run on different platforms, enabling you e.g. to do a Linux-to-Windows replication, monitor Linux-to-Linux replication using Windows client etc. This is always enabled and does not require any special configuration.
Dbvisit Replicate system requirements
• 100MB of space on the source and target servers for the Dbvisit Replicate software
• 200MB of space for the Dbvisit Replicate database repository in the Oracle database.
• ~1 – 2GB of memory on the source and target server (this can be reduced by setting
MEMORY_LIMIT_APPLY_MB and MEMORY_LIMIT_MINE_MB).
• sufficient space for text logs (and traces if enabled).
• About 10GB of space for redo logs, parsed logs and Dbvisit Replicate log and trace files
(1GB for test/dev systems)
Dbvisit Replicate Installation Guide and User Manual © Dbvisit Software Limited.
Except as specifically set out the Dbvisit license agreement, nothing in this Documentation constitutes a warranty as to the operation of the Dbvisit software.
page 12
