advertisement
▼
Scroll to page 2
of 56
INTRODUCTION
Board Dimensions
4 MB500 User’s Manual
INSTALLATIONS
Installations
This section provides information on how to use the jumpers and connectors on the MB500 in order to set up a workable system. The topics covered are:
Installing the Memory .................................................................. 6
Setting the Jumpers ...................................................................... 7
Connectors on MB500 ............................................................... 11
Watchdog Timer Configuration ................................................. 22
MB500 User’s Manual 5
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 5 MB500 Product Features
- 6 Checklist
- 7 Specifications
- 8 Board Dimensions
- 10 Installing the Memory
- 11 Setting the Jumpers
- 15 Connectors on MB
- 26 Watchdog Timer Configuration
- 48 VGA Drivers Installation
- 51 Audio Driver Installation
- 55 A. I/O Port Address Map
- 56 B. Interrupt Request Lines (IRQ)
- 11 Jumper Locations on MB
- 12 JP2: Voltage Setting for LVDS
- 12 JP6: Clear CMOS Contents
- 12 JP3, JP4, JP5: RS232/422/485 (COM2) Selection
- 13 JP7: Case Open Setting
- 13 JP8: CompactFlash Master/Slave Selection
- 13 JP2: Voltage Setting for LVDS
- 13 JP6: Clear CMOS Contents
- 13 JP3, JP4, JP5: RS232/422/485 (COM2) Selection
- 14 JP7: Case Open Setting
- 14 JP8: CompactFlash Master/Slave Selection
- 16 Connector Locations on MB
- 17 CN1: DC Jack (DC in, 12V only)
- 17 CN2: PS/2 Keyboard and Mouse Connectors
- 17 CN3: COM1 Serial Port
- 18 CN4: Parallel Port Connector
- 18 CN5: VGA CRT connector
- 19 CN6: 10/100 RJ45 Connector (for MB500F only)
- 19 CN7: 10/100 RJ45 and USB Connectors
- 19 CN8: Line Out, Line In, Mic Connector
- 19 CN9: Compact Flash Socket
- 19 PCI1: PCI Slot
- 19 DDR1: 184-pin DDR DIMM Socket
- 20 J2: ATX Power Supply Connector
- 20 J3: LVDS Connector
- 20 J4: LCD Inverter Connector
- 21 J5: LCD (TTL) Connector
- 21 J6, J7, J8: COM2, COM3, COM4 Serial Ports
- 22 J9: IrDA Connector
- 22 J10: Digital 4-in 4-out I/O Connector
- 22 J11: Mini PCI Socket
- 22 J12: For Right Speaker
- 23 J13: Wake On LAN Connector
- 23 J14: For Left Speaker
- 23 J15: USB Connector (USB2/USB3)
- 23 J16: Front I/O Connector
- 23 J17: Function Connector
- 24 J18: CD-In Audio Connector
- 24 FDD1: Floppy Drive Connector
- 25 IDE1: Primary IDE Connector
- 25 FAN1, FAN2: Fan Power Connectors