System Diagram. Hellenbrand ProMate-6, Iron curtain System 2.0

Iron Curtain

®

System – IC-10/IC-12

ITEM QTY.

NO. REQ'D.

PART

NO. DESCRIPTION

1.............1.............101065 ................................... IC-10 Rebed Mix

..............................101069 ................................... IC-10A Rebed Mix

..............................101068 ................................... IC-10+ Rebed Mix

..............................101070 ................................... IC-12 Rebed Mix

..............................101072 ................................... IC-12A Rebed Mix

..............................101071 ................................... IC-12+ Rebed Mix

2.............1.............107585 ................................... Aeration Assembly

3.............1.............104554 ................................... 1054 Vortech IC Filter Tank

..............................104561 ................................... 1252Vortech IC Filter Tank

3A ..........1.............104552 ................................... 10x54 IC-10 Aeration Tank

..............................104559 ................................... 12x52 IC-12 Aeration Tank

4.............1.............102792 ................................... 1” Check Valve (See pg 7)

..............................104174 ................................... Check Valve

5.............1.............102241, 101173 ..................... Distributor Tube for IC-10

..............................102238, 101173 ..................... Distributor Tube for IC-12

Control Valve Options for Filter Valves

6.............1.............104301 ................................... ProMate6-IC-10

..............................104302 ................................... ProMate6-IC-12

Not Shown ............101235 ................................... Bypass

Not Shown ............108038 ................................... Manual

14

FIGURE 8

Start-Up Instructions –

Complete wiring as seen on page 15 prior to startup.

1. Remove valve cover.

2. Remove drive bracket by lifting two tabs at top of back plate and lift bracket out of bottom supports; set aside.

3. With needle nose pliers, break plastic tab off bottom of LEFT cable guides so relay power supply can fit through.