28
WIRELESS PROGRAMMING (OPTIONAL ACCESSORIES)
Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one should enter or leave garage while door is in motion. Do not allow children to operate push button(s) or remote(s).
Do not allow children to play near the door.
NOTE: The transmitter(s) and wireless wall button supplied with your opener are preprogrammed by the factory.
If you purchase additional transmitters, the garage door opener must be programmed to accept the new remote code.
Program the Receiver to Match Additional Transmitter Codes:
Using the yellow “LEARN” Button
1.Press and Hold the button on the hand-held remote or wall button that you wish to use (1).
2.Press and release the yellow “LEARN” buton on the opener (2).
3.Release the remote button when the opener light flashes. It has learnt the code. If you release the remote control push button before the opener light flashes, the opener has not learned the code.
Now the opener will operate when the remote control push button is pressed.
1
To Erase all Remote Control Codes
1.Press and Hold the yellow “LEARN” button on the opener until the indicator LED goes ON, and continue holding for approx. 6 seconds, until the indicator LED goes out.
1.Release the button, all codes are now erased.
2
2
Yellow “Learn” Button
1
Locate the yellow learn button
Press and release the yellow learn button
Wireless Keypad E840M
To set the keyless entry PIN:
1.Locate the yellow “LEARN” button on the garage door opener.
2.Press and release the yellow “LEARN” button. The LED indicator light will glow steadily.
3.Enter a 4-digit personal identification number (PIN) of your choice on the keypad.
3
4
4.Press and hold the ENTER button. Check to see if the opener light flashes. Release the ENTER button after the light flashes.
To change an existing keyless entry PIN:
1.Enter the existing programmed PIN that you want to change.
2.Press and hold the # button until the courtesy light flashes twice.
3.Enter the new 4-digit PIN of your choice, then press the ENTER button. The light will flash once.
4.To test, enter the new PIN, then press the ENTER button. The garage door opener will activate.
3
16
Enter a 4-digit
PIN of your choice
Press and hold the enter button
Opener light flashes
After the lights flash release the
ENTER button
