advertisement
ERROR MODE
WARNING/LAMP indicator, ON indicator, and STANDBY indicator diagnose error mode of the projector as follows.
Error mode
Lamp cover
WARNING
/LAMP
ON
Indicators
ON
OFF
STANDBY
Flashing
Possible Cause
Lamp
Temperature
Fan
Color temperature adjustment
Other
ON
Flashing
Flashing
ON
Flashing
OFF
OFF
OFF
OFF
OFF
OFF
Flashing
ON
ON
OFF
The lamp cover is not closed properly.
The lamp has failed, or the lamp is completely worn out.
Projector internal temperature is higher than the allowed level.
Trouble has occurred with the fan.
Color temperature adjustment failed.
Internal program error
Recommendation
Close the cover correctly.
Replace the lamp and reset lamp life.
Check if anything is blocking the exhaust vent.
Retry adjustment.
Shut power OFF and
ON again.
ON SCREEN MESSAGE
Use the list below to check the message displayed on the screen.
Message
NO SIGNAL
REPLACE LAMP!
No input signal.
Meaning
The lamp has reached the end of its life.
Improper signal feed to the projector.
OUT OF RANGE
Remedy
Properly connect the cables.
Replace the lamp and reset lamp life.
Adjust resolution, V(Hz) : refresh rate of the equipment, referring to the Timing Chart.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement