NP320 Lift Around

How to Use

Align arrows to attach tool caddy

Pull out to remove tool caddy

Fig. 1 Fig. 2

Fig. 3

Fig. 4

Power

Button

Fig. 6

Fig. 5

ASSEMBLING THE LIFT-AROUND

™

PORTABLE VAC

1

Insert the end of the flexible hose into the connector on the back of the Lift-Around™

Portable Vac. (fig. 1)

2

Insert the removable tool caddy onto the front of the Portable Vac. (fig. 2) To remove the tool caddy, hold the vacuum by the handle, pull out slightly from the right side and then remove it from the Portable Vac. (fig. 3)

3

Insert the crevice tool, dusting brush, upholstery brush or power brush into the openings on the tool caddy. (fig. 3)

4

Attach the shoulder strap onto the hooks on the handle of the Portable Vac. (fig. 4)

5

Empty Dust Cup after cleaning and periodically during cleaning when it appears full. (See

“Maintenance” section for instructions.)

8

TOLL FREE: 1-800-798-7398

FOR ADDED COMFORT OR FOR AN EXTENDED

REACH

6

Attach the floor kit handle to the flexible hose.

Push it in until it is secure. (fig. 6)

7

Insert the telescopic tube into the end of the floor kit handle. Push it in until it is secure. (fig. 6)

NOTE: All accessories may be used with the flexible hose, the floor kit handle or the telescopic tube.

8

Attach the desired accessory to the end of the flexible hose, floor kit handle or telescopic tube by pushing it in until it is tightly secured. (fig. 6)

9

While holding the Portable Vac by the handle, press down on the power button to turn the

Portable Vac on and begin vacuuming. Press down again to turn the vacuum off. (fig. 5)

NP320_40_IB_ENG_120210_1.indd 8 12-02-14 10:02 AM