- No category
advertisement
▼
Scroll to page 2
of 119
Table 9–1
2. Plug the VGA–12 adapter cable into J1 on the XE–900 SBC.
3. Plug the DB–15 end of the VGA–12 cable into the VGA cable of the monitor.
Refer to Figure 9–1.
J1 – CRT connector
J1, CRT Connector
Pin # Pin Name Pin Name Pin #
3 BL
5 +5V
GND 4
GND 6
Figure 9–1 The XE–900 SBC and a VGA monitor
VGA Monitor
PS/2 Keyboard
2 mm VGA-12 cable
Power Supply
Dot indicates pin 1
.
XE–900
68
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 67 Copyright
- 67 Disclaimer
- 67 Technical Support
- 67 Revision History
- 68 Using CMOS circuitry in industrial control
- 69 Avoiding damage to the heatsink or CPU
- 69 Excessive Thermal Stress
- 70 Table of Contents
- 74 List of Figures
- 75 List of Tables
- 76 Overview: Section 1 – Installation
- 77 Chapter 1: Overview
- 77 Description
- 77 XE–900 SBC major hardware features
- 77 Cooling
- 77 SDRAM
- 77 On-board flash
- 77 CompactFlash socket
- 78 Hard disk and IDE port
- 78 USB ports
- 78 LPT and floppy
- 78 Digital I/O
- 78 Ethernet
- 78 Serial ports protected against ESD
- 79 PC/104 and PC/104-Plus interface
- 79 Video
- 79 Keyboard, mouse, and speaker ports
- 79 Real time calendar/clock with battery backup
- 79 Setup information stored in Flash for high reliability
- 79 User-available EEPROM
- 79 Watchdog timer added for safety
- 80 Hardware reset
- 80 5 Volt only operation lowers system cost
- 80 Rugged environmental operation
- 81 XE–900 SBC major software features
- 81 Diagnostic software verifies system integrity automatically
- 81 General Software BIOS
- 81 Octagon BIOS extensions
- 81 Boot sequence
- 82 Chapter 2: Quick start
- 82 Component diagrams, connectors, switches and cables
- 86 XE–900 SBC connectors and jumpers
- 87 Custom cables
- 88 Mounting the XE
- 88 Equipment required
- 89 Hardware mounting
- 90 XE–900 SBC power supply requirements
- 91 Connecting a monitor and keyboard
- 91 Monitor
- 91 Keyboard and mouse
- 92 Installing an operating system
- 92 OS on CD-ROM onto a hard drive or CompactFlash
- 95 Chapter 3: Setup programs