2
Select the method you want to use for time:
Set Date & Time Manually: Allows you to select the current time. Click this option to select the year, month, day, hour, and minutes in your current time zone, then click OK.
Set Up NTP: Allows you to specify the IP address of an NTP server. Click Set Up NTP. Use the public pool.ntp.org server or click New, then specify the IP address of an NTP server. To accept the configuration, click OK.
If the time on the machine is wrong by more than an hour, use both methods to set the time. Set it manually first, and then configure it to use NTP.
3
In the Time Zone section, select your time zone, then click OK.
Regardless of the method you used to set the time, you must select a time zone.
4
To save the changes to browser cache, click OK.
5
To apply your changes, click Devices > Access Gateways, then click Update > OK.
6
Continue with “Enabling Trusted Authentication” on page 25 .
1.5.2
Enabling Trusted Authentication
Trusted authentication requires an authentication contract that specifies the type of authentication credentials. The Identity Server and the Access Gateway control these authentication requirements.
You do not need to configure your Web server to require authentication. Access Manager enforces the requirements for you.
In this example, you set up an authentication contract that requires a username and a password to access a directory on a Web server.
1
In the Administration Console, click Devices > Access Gateways, then click Edit > [Name of
Reverse Proxy] > [Name of Proxy Service] > Protected Resources > New.
2
Specify a display name for the protected resource, then click OK.
3
Select either the Name/Password - Basic or the Name/Password - Form for the Authentication
Procedure:
Name/Password - Basic: Basic authentication over HTTP using a standard login page provided by the Web browser.
Name/Password - Form: Form-based authentication over HTTP.
Others are available, but for this basic setup, which does not enable SSL, select one of the above contracts. The contract needs to match the protocol.
Setting Up a Basic Access Manager Configuration
25
