Hx1/Hx2 User Manual

32 | Section 4

Factory Default Configuration Settings

These settings will work in most cases and should be considered to be a “starting point”.

The following is the Factory Default Configuration for the SETTINGS, OPTIONS, and

Internal Telephone Network/Call Progress Tone Detection (CPTD) DIP switches:

Bit 5

OFF SETTINGS

Bits 1 and 2

Bits 3 and 4

Bits 5 and 6

Bits 7 and 8

Bit 1

OFF

Bit 2

OFF

Bit 3

OFF

EQ LO, fixed dB gain adjustment

EQ HI, fixed dB gain adjustment

Ducker dB gain adjustment

AGC and Noise Gate settings

Bit 4

OFF

Bit 6

ON

Bit 7

ON

Bit 8

OFF

=> 0 dB gain

=> 0 dB gain

=> -6 dB ducking

=> AGC is FULL, Noise Gate is OFF

OPTIONS

Bits 1 and 2

Bits 3 and 4

Bit 5

Bit 6

Bit 7

Bit 8

Bit 1

ON

Bit 2

OFF

Bit 3

OFF

DDEQ configuration

Auto-Answer configuration

Send gain to phone

Hx2 internal mix-minus enable

Feedback Reduction enabled

Reserved

Bit 4

OFF

Bit 5

OFF

Bit 6

OFF

Bit 7

OFF

Bit 8

OFF

=> Dynamic EQ is enabled

=> feature is OFF

=> feature is OFF

=> feature is OFF

=> feature is OFF

INTERNAL

Bits 1 through 4

Bits 5 through 8

Bit 1

OFF

Bit 2

OFF

Bit 3

OFF

Telephone Network configuration

Call Progress Tone Detection

Bit 4

OFF

Bit 5

OFF

Bit 6

OFF

Bit 7

OFF

=> USA, Canada

=> USA dial tone

Bit 8

OFF