Sophos Mobile Control
14. After installation has finished, the Sophos Mobile Control - Installation finished dialog is displayed. Make sure that the check box Start Sophos Mobile Control server now is selected and click Finish to start the Sophos Mobile Control service for the first time.
Note: After the service has been started it can take a few minutes before the Sophos Mobile
Control web interface is available.
After the installation there are a few initial configuration steps that you need to perform:
■
■
Log in to the Sophos Mobile Control web console for the first time to run the configuration wizard.
For iOS devices, you need to get an Apple Push Notification service certificate.
■
Optionally, you can set up a standalone EAS proxy for email filtering that has the following advantages over the internal EAS proxy that is automatically installed with Sophos Mobile
Control:
■
■
■
Support for certificate-based client authentication.
Lotus Traveler client support for non-iOS devices.
Support for multiple Exchange and Lotus Traveler servers.
See the Sophos Mobile Control Startup guide for details of these configuration tasks.
5.3 Change the SQL login language
If you have configured Sophos Mobile Control Server to use SQL Server authentication to connect to the database, the SQL login language must be set to English. Otherwise, an error occurs when the Sophos Mobile Control service is started.
This topic describes how to change the SQL login language to English.
1. Stop the Sophos Mobile Control service.
2. Open SQL Server Management Studio on the server and select Security > Logins.
3. On the General page of the Login Properties, set Default language to English, then click
OK to save the changes.
4. Restart the Sophos Mobile Control service.
16
