- No category
advertisement
2.6.4 Connecting Asynchronous Modems
You can connect up to eight asynchronous modem lines to the CXY08 module. To connect a modem to a CXY08 module, see Figure 2–22 and perform the following:
1.
Find the BC19N–12 cable (see Figure 2–21).
Figure 2–21: BC19N-12 Cable
MLO-007134
2.
Feed the socket end of the cable under the cable management bracket from the back of the cabinet and insert it into the CXY08 module connector (see Figure 2–22).
Installation 2–37
Figure 2–22: CXY08 Module Connector
• If you are going to use both BC19N–12 cables, connect the first cable to the connector labeled 4–7 on the CXY08 module cover.
• If you are going to use only one cable, connect the cable to the connector labeled 0–3.
2–38 Installation
3.
Lock the connector into place with the bail latches.
4.
Attach one to four modems to the connectors at the opposite end of the cable.
If you want to place the modem farther away from the system, attach a BC22F extension cable between the cable assembly and the modem
(see Figure 2–23).
Refer to the modem documentation for the location of the connector, and for instructions on using the modem.
Figure 2–23: BC22F Extension Cable
Extension Cable
MLO-007189
Repeat the same procedure for connecting a second BC19N cable, except insert the cable into the connector labeled 0–3.
Installation 2–39
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 1 Introduction
- 5 Major Units
- 5 Front Assemblies
- 5 Mass Storage Shelf
- 6 System Control Panel
- 10 System ON/OFF Switch
- 10 Card Cage
- 10 Memory Modules
- 10 Q–bus Option Modules
- 13 Console Bulkhead Assembly
- 19 Power Supply Controls and Indicators
- 39 Verifying Site Preparation
- 40 Tools Required
- 40 Checking the Shipment
- 44 Installing the Rack-Mountable VAX 4000 Model
- 44 Installing Equipment Slides
- 50 Attaching Chassis Mounting Brackets
- 52 Mounting Chassis on Equipment Slides
- 53 Installing the Cable Management Bracket
- 53 Installing the Cable Tie Bracket
- 55 Setting System Controls
- 61 Connecting Additional Devices to the System
- 64 Connecting Terminals and Serial Printers
- 70 Connecting Parallel Printers
- 72 Connecting Synchronous Modems
- 75 Connecting Asynchronous Modems
- 78 Assembly
- 80 Console Bulkhead Assembly
- 87 Module
- 87 DESQA Module
- 96 Connecting an Embedded TLZ-Series Tape Drive
- 98 Installing the R400X Expander
- 98 Cabling
- 98 Connecting the Q–bus Cables
- 100 Connecting the DSSI Cable
- 102 Connecting the KZQSA External Cable
- 104 Connecting the Power Control Bus Cable
- 106 Connecting the Ground Cable