advertisement
Enable Disable
If “Talk Around” is programmed, the TX frequency can be changed to be the same as the RX frequency. The CTCSS/CDCSS encode and decode tones change respectively. To enable or disable the “Talk Around” feature, press the [TA] key.
Enable Disable
DTMF SELECTIVE CALL
■ MANUAL DIAL
While pressing the [PTT] button, press the DTMF keys to transmit the corresponding DTMF tones. The DTMF tones can be heard when a key is pressed. The radio can be programmed by the dealer to continue transmitting for 2 seconds after the [PTT] button is released. Therefore, in the 2 seconds, a DTMF code can be transmitted without pressing the [PTT] button. The [A], [B],
[C] and [D] keys can be programmed as active or inactive DTMF keys.
■ STORE AND DIAL
If the dealer enables this feature, a DTMF code with up to 16 digits can be sent when the [DIAL] key is pushed.
• If [A], [B], [C] and [D] keys have been set as inactive in the manual dial mode, these keys still can be used in this feature.
• The ”[D]” key can be programmed as a null tone (delay) by the dealer. (i.e., the “D” tone is not transmitted, it only represents a pause time.)
■ AUTO-DIAL
This function is enabled or disabled by the dealer.
STORING A DTMF CODE
One DTMF code with a maximum of 16 digits can be stored in any one of the ten numbered keys,
[0]-[9]. Press the [DIAL] key and then press the [#] key. The LCD display is shown below. Enter the code to be stored (16 digits maximum) with the keypad, and press the [DIAL] key. Select a numbered key [0]-[9] to store the code into the memory location.
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 4 User Safety, Training, and General Information
- 4 Compliance with RF Energy Exposure Standards
- 5 FCC Compliance
- 5 Precautions
- 7 Supplied Accessories
- 7 Charging The Battery
- 8 Battery
- 8 Unit with belt clip
- 8 Antenna
- 8 External Speaker Microphone
- 9 Belt Clip
- 11 LCD Icons
- 12 POWER
- 12 VOLUME
- 12 MONITOR
- 12 SELECT CHANNEL
- 12 SELECT SQUELCH LEVEL
- 13 RECEIVE
- 13 TRANSMIT
- 13 SELECT TRANSMIT POWER
- 13 CONNECT ID/DISCONNECT ID
- 14 CHANNEL SCAN
- 15 FREQUENCY REVERSE/TALK AROUND
- 16 DTMF SELECTIVE CALL
- 17 CODE SQUELCH
- 18 SELECTIVE CALLIING
- 18 TWO-TONE SELECTIVE CALL
- 18 SELECTABLE CTCSS
- 18 AUTO-RESPONDER
- 19 CALL ALERT TONE