- No category
advertisement
COOLING FAN
1. Follow the LOCKOUT/TAGOUT procedure using the procedures provided in the Lockout/
Tagout Procedures section of this manual.
2. Remove the Power Head Lid following the instructions provided in the Panels and Covers section of this manual.
3. Unplug the leads from the fan.
4. Remove the four screws securing the fan to the Power Head.
Figure 10: Cooling Fan
5. Reverse this procedure to install the new
Cooling Fan.
WARNING
Before removing any sheet metal panels or servicing this equipment, always perform the Electrical LOCKOUT/TAGOUT Procedure.
Be sure all circuits are disconnected. Failure to comply with this procedure can cause property damage, injury or death.
WARNING
Certain components may be hot if the unit was in operation prior to performing a procedure. Allow the unit to cool before beginning work.
POWER CORD
1. Follow the LOCKOUT/TAGOUT procedure using the procedures provided in the Lockout/
Tagout Procedures section of this manual.
2. Remove the Power Head Lid following the instructions provided in the Panels and Covers section of this manual.
3. Disconnect the Power Cord from the Contactor and remove the ground screw securing the green ground wire to the unit’s chaise.
4. Refer to the unit’s schematic, connect the new power cord.
5. Restore power to the unit.
6. Verify unit is working properly.
7. Remove the unit from its power supply.
8. Reattach the Power Head Lid
9. Restore power to the unit and ensure unit is operating correctly.
POWER BOARD COMPONENTS
The Power Board Components include the Solid
State Relay, Contactor, 120VAC Float Board and the Neutral Lug. Under normal circumstances it should not be necessary to replace either the
Contactor or Neutral Lug.
120VAC
Float
Board
Neutral
Lug
Contactor
Solid State
Relay
Power
Board
Figure 11: Power Board Component Locator
NOTICE: The Power Board is mounted on plastic risers that allow for air flow on the underside of
— 13 —
advertisement
* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project
Related manuals
advertisement
Table of contents
- 5 ELECTRICAL LOCKOUT/TAGOUT PROCEDURE
- 6 COVERS AND PANELS
- 6 Top Fill Cover
- 6 Power Head Lid
- 6 Units with Doors
- 7 COMPONENT LOCATOR
- 7 Power Head Components
- 8 Delivery Manifold Components
- 9 Return Manifold Components
- 10 COMPONENT REMOVAL AND REPLACEMENT
- 10 ELECTRICAL COMPONENTS
- 10 Power Toggle Switch
- 11 Add Fluid Light
- 11 Temperature Controller
- 13 Cooling Fan
- 13 Power Cord
- 13 POWER BOARD COMPONENTS
- 14 Solid State Relay
- 15 120VAC Float Board
- 15 300NDNL TWELVE BUTTON TIMER
- 16 PLUMBING COMPONENTS
- 16 B&G Pump
- 18 Teflon Hoses
- 19 Fluid Level Probes
- 20 Snap Disc
- 21 Thermocouple
- 22 Heat Elements
- 25 MAINTENANCE PROCEDURES
- 25 Temperature Controller Set Up Procedures
- 25 Unlock the Controller
- 25 Set Up
- 27 9300 Ogden Throwback Controller
- 29 Changing the Heat Transfer Fluid
- 30 CT Door Adjustment
- 31 Stainless Steel Care
- 31 Cleaning
- 31 Preserving & Restoring
- 31 Heat Tint
- 32 TROUBLESHOOTING
- 33 WIRING SCHEMATICS
- 35 WARRANTY
- 35 HEAT TRANSFER FLUID MSDS