I SERIES SM-S220 Hardware Manual

2. Setup

2.1 Battery Pack

2.1.1 Inserting into the Printer

1. Make sure that the printer has been turned off before you insert or remove the battery pack.

OFF ON

2. Insert the battery pack into the back of the printer as in the figure shown below, following the direction of the arrow.

3. To remove the battery back, pull back the hook, and use the opposite procedure from the one you used to insert the battery pack.

Push the battery pack until the hock clicks into place.

Hook

4. The battery pack install into External Battery Cradle.

Insert the battery pack in the direction of the arrow.

- 4 -