Cleaning cooktop and parts. Electrolux 316471400, 316471110, EI30GF55G - 30" Gas Range, 30" FREE-STANDING GAS WAVE-TOUCHTM RANGE 316471110, EI30GF55GS - 30 Inch Gas Range, EW30GF65GB - 30" Gas Range, EW30GF65GS - 30" Gas Range, EW30GF65G - 30'' Gas Range

Care and Cleaning 53

Cleaning cooktop and parts

The cooktop is designed to make cleaning easier.

Because the gas burners are sealed, cleanups are easy when spillovers are cleaned up immediately.

IMPORTANT

• The cooktop is not removable. Do not attempt to remove or lift the cooktop.

• Do not allow spills, food, cleaning agents or

any other material to enter the gas orifice port -Fig 1.

Cooktop

If a spill occurs on or in the recessed or contoured areas, blot up spill with an absorbent cloth. Rinse with a clean, damp cloth and wipe dry. Do not use harsh abrasive cleaners on the cooktop. They can scratch the porcelain. Completely rinse any mild cleaners used from the surface or the porcelain cooktop may become damaged during future heating. Do not use spray oven cleaners on the cooktop.

Your range is shipped with the burner heads and burner caps in the correct locations. Before using your gas range make sure to:

• Follow the installation instructions before installing.

• Remove all packing tape from cooktop area.

To remove:

Should you ever need to remove the burner cap for cleaning, simply lift the cap off the burner head.

To replace:

1. Pair up burner caps sizes with corresponding burner heads.

2. Align burner cap ignition area to the burner head ignition area. See illustration.

3. Place the burner cap vane slots onto the burner head vanes.

Before using make sure the burner cap fits

flush with the burner head.

Burner Cap

Burner cap vane slots

Burner grates

The burner grates are dishwasher safe and may be cleaned in the dishwasher. Remove any excessive soils before placing in the dishwasher.

Before placing burner grates onto cooktop, turn grates over to identify rear of grate and place all the grates to the rear of the cooktop.

Burner heads & caps

Burner head ignition area

Burner port

Burner cap ignition area

Do not remove any parts from the cooktop until they have completely cooled and are safe to handle. Do not operate the surface burners without the burner caps.

Burner head vanes

Burner Head

To clean:

The ports (or slots) around the burner heads must be routinely cleaned. If residue still remains in these ports, use a small-gauge wire or needle to clean the slots or holes. For proper flow of gas and ignition of the burner— Always keep the burner caps in place whenever the gas burners are in use.

Fig. 1

Double ring burner heads & caps

The glass in the double ring burner is designed to fit loosely. Clean with normal non-abrasive glass cleaners and thoroughly dry before replacing.