9.1.16 ISDN (INTEGRATED SERVICES DIGITAL NETWORK) FEATURES
KX-NT265
KX-NT265 (version 2.00 or later)
KX-NT300 series (except KX-NT366/KX-NT305)
KX-NT400/KX-NT366/KX-NT305
V-IPEXT Card
ü
ü
ü
IP-EXT Card
ü
ü
ü
Installation Manual References
KX-TDE100/KX-TDE200
3.4.1 Virtual Cards
3.6.8 IP-EXT16 Card (KX-TDA0470)
KX-TDE600
3.4.1 Virtual Cards
3.8.8 IP-EXT16 Card (KX-TDA0470)
PC Programming Manual References
3.14 [1-1] Slot—Card Property - Virtual IP Extension
3.15 [1-1] Slot—Port Property - Virtual IP Extension
3.41 [1-1] Slot—Card Property - IP Extension
3.43 [1-1] Slot—Port Property - IP-Extension Port
9.1.16 ISDN (INTEGRATED SERVICES DIGITAL NETWORK)
FEATURES
Description
Integrated Services Digital Network (ISDN) is a digital switching and transmission network. ISDN transmits voice, data, and image in digital format. ISDN lines can be connected to public lines (CO lines), private lines
(QSIG).
1.
ISDN Interface and Configuration
Interface Type Description Port Mode
CO Line, QSIG—
Master, QSIG—
Slave
*1
Primary Rate Interface
(PRI)
Provides twenty-three 64 kbps B channels for communication and one 64 kbps D channel for signaling (23B + D).
*1
3.33 [1-1] Slot—Port Property - PRI Port—Main— Port Type
2.
ISDN Supplementary Services for Public Network
Service
Direct Inward Dialing
(DID)
Description
Directs a call with a DID number to the preprogrammed destination.
Details in
® 4.1.6 DID (Direct
Inward Dialing)
Document Version 2009-12 Feature Manual 169
9.1.16 ISDN (INTEGRATED SERVICES DIGITAL NETWORK) FEATURES
Service
Calling Line
Identification
Presentation (CLIP)
Connected Line
Identification
Presentation (COLP)
Description
Sends the caller’s telephone number to the network when making a call. The called party can see the number on his or her telephone display before answering the call.
Sends the telephone number of the answered party to the network when answering a call. The caller can see the number on his telephone display when the line is connected.
Prevents the caller’s CLI from being presented to the called party.
Details in
® 3.1.15 CLIP
(Calling Line
Identification
Presentation)
Calling Line
Identification
Restriction (CLIR)
Connected Line
Identification
Restriction (COLR)
Caller ID
Prevents COLP from being sent by the answered party.
The PBX receives Caller ID information, such as the caller’s name and telephone number, when a call is sent from the network. A display proprietary telephone (PT) user can see this information before answering the call.
® 3.1.3 Caller ID
3.
Private Networking Connection (QSIG)
Private networking with QSIG is possible using an ISDN line. Each ISDN port must be programmed so that each ISDN line has a "master" connection and a "slave" connection.
Conditions
•
En bloc
The PBX sends all of dialed digits at once after the extension user completes dialing. The PBX recognizes the end of dialing as follows:
– the # key is pressed (programmable).
4.18 [2-9] System Options—Option 2— End of Dial Plan—[#] as End of Dial for en Bloc mode
– the dialed number is a preprogrammed telephone number.
5.4 [3-1-4] Dialing Plan
– the inter-digit timer expires.
4.5 [2-3] Timers & Counters—Dial / IRNA / Recall / Tone— Dial—Extension Inter-digit
•
Extension Number
An extension number can be assigned to each ISDN port.
6.1 [4-1-1] Wired Extension—Extension Settings—Main— Extension Number
•
Network Type
Each ISDN port can be set to the requirements of each country/area.
•
L1 Active Mode and L2 Data Link Mode
The active mode of Layer 1 (L1) and the data link mode of Layer 2 (L2) can be selected individually
(Permanent or Call by Call) for each ISDN port.
•
TEI Assignment Mode
The Terminal Endpoint Identifier (TEI) assignment mode can be selected for each ISDN port.
•
Bearer Mode
The bearer mode can be assigned for each ISDN port.
6.1 [4-1-1] Wired Extension—Extension Settings—Option 7— ISDN Bearer
6.10 [4-2-1] Portable Station—Extension Settings—Option 7— ISDN Bearer
170 Feature Manual Document Version 2009-12
9.1.16 ISDN (INTEGRATED SERVICES DIGITAL NETWORK) FEATURES
PC Programming Manual References
3.32 [1-1] Slot—Card Property - PRI type
3.33 [1-1] Slot—Port Property - PRI Port
3.34 [1-1] Slot—Port Property - PRI Port—Connection Command
4.5 [2-3] Timers & Counters—Dial / IRNA / Recall / Tone— Dial—Extension Inter-digit
4.18 [2-9] System Options—Option 2— End of Dial Plan—[#] as End of Dial for en Bloc mode
6.1 [4-1-1] Wired Extension—Extension Settings
→Main— Extension Number
→Option 7— ISDN Bearer
6.10 [4-2-1] Portable Station—Extension Settings—Option 7— ISDN Bearer
5.5 [3-1-4] Dialing Plan—Auto Assign
Feature Manual References
13.1.20 PRIVATE NETWORK FEATURES—QSIG
Document Version 2009-12 Feature Manual 171
9.1.16 ISDN (INTEGRATED SERVICES DIGITAL NETWORK) FEATURES
172 Feature Manual Document Version 2009-12
