Chapter 13: Programming Features
Store the program line by line
Execute the program
When a line exceeds the width of the screen, the display will shift to the left.
12. Press
E.
The cursor will move to the next line and the data input will be stored.
Store the program line by line by pressing
E, { or
}.
13. Press
@ q to exit the program edit screen.
14. Press
P A.
A list of stored programs will appear.
15. Press
0 1 to execute the program 01
“HELLO”.
2. Programming Hints
Editing the program
Press
P B and then the appropriate numbers to open the stored program.
Adding commands, strings or command lines to the program
Entering alphabetical characters
(uppercase only)
Press
@ i to enter the insert type mode.
Press
E to go to the next line. Be sure to press @ i again to turn off the insert type mode and return to type over mode.
Press
E twice to insert a blank line.
Press
A to enter characters. Press @ . to use a
ALPHA-LOCK mode to input a series of alphabetical characters.
Inputting commands
In general, only a single command can be input per line.
204
Chapter 13: Programming Features
Storing a program line by line
After pressing
E, } or {, the line will be stored in memory. Otherwise, it is not stored. Be sure to store the all lines by pressing
E ({ or }) before quitting editing
(pressing
@ q).
Blank line
Deleting a line
Deleting command or strings
Deleting an entire program
Copying a line to another location
Changing the program name
Re-executing the program
Break the execution process
Blank lines are ignored during execution. You can include blank lines to gain better readability.
Move the cursor to the line you wish to delete and press
C.
Move the cursor to on or after the letter you wish to delete and press
D or B, respectively.
Press
@ p and use C DEL. (See Chapter 14 OPTION
Menu, page 224).
Press
P H in the program edit mode. (See page 216 for details)
Press
Press
{ to move the cursor to the program name field. Enter the new name and press
Pressing
E or }.
E again after execution of the program completes.
O or @ q to break the execution process.
205
