Kenmore®

Straight

Hold coupling nut and regulator as shown for proper connection to LP tank valve.

Leak Testing Valves, Hose and Regulator

1. Turn all grill control knobs to OFF.

2. Be sure regulator is tightly connected to LP tank.

3. Completely open LP tank valve by turning OPD hand wheel counterclockwise. If you hear a rushing sound, turn gas off immediately. There is a major leak at the connection.

Correct

before proceeding

by calling for replacement parts at

1-800-4-MY-HOME

.

®

4. Brush soapy solution onto areas where bubbles are shown in picture below:

Never remove threaded

orifice at end of valve.

6. Turn the coupling nut clockwise and tighten to a full stop. The regulator will seal on the back-check feature in the LP tank valve, resulting in some resistance. An additional one-half to

three-quarters turn is required to complete the connection. Tighten by hand only – do not use tools.

NOTE:

If you cannot complete the connection, disconnect regulator and repeat steps 5 and 6. If you are still unable to complete the connection, do not use this regulator!

®

Call 1-800-4-MY-HOME for identical replacement parts.

DANGER

• Do not insert any tool or foreign objects into the valve outlet or safety relief valve. You may damage the valve and cause a leak. Leaking propane may result in explosion, fire, severe personal injury, or death.

• If a leak is detected at any time, STOP and call the fire department.

• If you cannot stop a gas leak, immediately close LP tank valve and call LP gas supplier or your fire department!

5. If “growing” bubbles appear, there is a leak. Close LP tank valve immediately and retighten connections. If leaks cannot

be stopped do not try to repair. Call for replacement parts at 1-800-4-MY-HOME.

®

6. Always close LP tank valve after performing leak test by turning hand wheel clockwise.

WARNING

• Never attempt to attach this grill to the self-contained LP gas system of a camper trailer or motor home.

• Do not use grill until leak-tested.

10 • 464424312 • 464424512