Connection to a PC through WinDNC. Fagor CNC 8055 para otras aplicaciones, CNC 8055 for lathes, CNC 8055 para tornos, CNC 8055 for other applications

Operating manual

3.2

Connection to a PC through WinDNC

The PC operative system must be Windows

®

and it must have the WinDNC software installed (V4.0

or newer). The CNC must be configured just like another node within the local network or internet.

i

The access to a DNC server is configured by machine parameters. Refer to the chapter on machine parameters for Ethernet in the installation manual.

Possible connections:

• From a PC.

The connection may be initiated at any PC and addressed to any CNC. Two PC's cannot be connected to each other.

To establish the connection, the WinDNC allows the user to enter the CNC's IP address to be used for the connection.

• From a CNC.

The connection is always addressed to the DNC server. The DNC server is defined by machine parameters.

Communication status

As with the communication via serial line, the DNC status screen shows its status through Ethernet.

When having the DNC available, the top of the screen shows the message" DNC E". The connection may be activated and deactivated from the softkey menu.

It is possible to connect several WinDNC (up to 10) simultaneously to the same CNC. The access protection is by operation. If several WinDNC initiate an operation, the commands are processed one by one while the rest of the WinDNC's wait.

3.

CNC 8055

CNC 8055i

·T· M

ODEL

S

OFT

: V01.6

X

·45·